NCP15XV103J03RC Murata Electronics North America, NCP15XV103J03RC Datasheet - Page 43

• Manufacturer Part Number: NCP15XV103J03RC
• Description: THERMISTOR
• Manufacturer: Murata Electronics North America

Specifications of NCP15XV103J03RC

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. This product is designed for the Switching Power
2. Use this product within the specified maximum
3. Use this product with smoothing capacitor within
4. This product is designed for application in an
Be sure to provide an appropriate fail-safe function
on your product to prevent secondary damages that may be
caused by the abnormal function or the failure of our
product.
To keep solderability of product from declining, the
following storage condition is recommended.
1. Storage condition:
2. Storage term:
Use this product within the specified temperature
range.
Higher temperature may cause deterioration of the
characteristics or the material quality of this
product.
1. Be sure that the preheat-up does not melt the
2. Do not touch the body with soldering iron.
Temperature -10 to +40 degrees C
Humidity less than 75%RH (not dewing condition)
Use this product within 6 months after delivery by
first-in and first-out stocking system.
!Caution (Storage and Operating Conditions)
Supply with smoothing capacitors.
Other applications of this product may result in
fire.
current. Otherwise it may catch fire in the worst
case.
the specified maximum capacitance value. Otherwise
it may catch fire in the worst case.
ordinary environment
(normal room temperature, humidity and atmospheric
pressure).
Do not use under the following conditions because
all these factors can deteriorate the
product characteristics cause failure and burn-out.
!Caution (Others)
Notice (Storage and Operating Conditions)
Notice (Rating)
Notice (Soldering and Mounting)
soldering of this product. Excessive heat may
cause failure to open, short or insulation break
down.
The soldering point should be min. 5mm away from
the root of lead wire.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
for Inrush Current Suppression Lead Type !Caution/Notice
3. Handling after unpacking:
4. Storage place:
(1) Corrosive gas or deoxidizing gas.
(2) Volatile or flammable gas
(3) Dusty conditions
(4) Under high or low pressure
(5) Wet or humid conditions
(6) Near with salt water, oils, chemical liquids or
(7) Strong vibrations
(8) Other places where similar hazardous conditions
After unpacking, reseal product promptly or
store it in a sealed container with a drying agent.
Do not store this product in corrosive gas
(Sulfuric acid gas, Chlorine gas, etc.) or in direct
sunlight.
(Chlorine gas, Hydrogen sulfide gas, Ammonia
organic solvents
exist.
gas, Sulfuric acid gas, Nitric oxide gas, etc.)
R44E.pdf
41
10.2.22
8