1.74.506.001/1300 RAFI, 1.74.506.001/1300 Datasheet - Page 3
![LIGHT BEZEL, RAFIX 22 FS](/photos/19/39/193963/114205506-40_sml.jpg)
1.74.506.001/1300
Manufacturer Part Number
1.74.506.001/1300
Description
LIGHT BEZEL, RAFIX 22 FS
Manufacturer
RAFI
Datasheet
1.1.30.253.5010300.pdf
(29 pages)
Specifications of 1.74.506.001/1300
Colour
Transparent Red
For Use With
RAFIX 22 FS Signal Indicators
RAFIX 22 FS
Cast-on
collar seal
Special sealing
Control Components
Combined with short-travel keys
The actuators of the RAFIX 22FS system are suited for
integration into low-profile data entry systems. The small
soldered directly onto the printed circuit board. In order
to ensure full illumination, the LED must be mounted on
a base. Bases are available as accessories.
Sealed against moisture and dirt
O-ring seal
The O-ring seals the space between the lens and the
actuator. The cast-on collar seal cannot be lost or distor-
ted during assembly. During assembly, the actuator is
held in the mounting hole by the cast-on seal and can
then be fixed by screwing from the rear.
The special membrane seal safely prevents moisture, oil
or dust from reaching the contact block.
In contrast with seals sliding up and down along the
shaft, the special membrane seal is arranged in a fixed
position on the housing. In this way, RAFIX 22 FS guaren-
tees switching raliability for the full service life (degree of
protection IP65 to DIN).
mounting depth and the PCB solder terminals make it
possible to combine the contact blocks with RAFI
short-travel keys RACON 8 an 12, RF 15 and RF
19 as well as KN 19 on one and the same
als illuminated with superbright LEDs
printed circuit board.
together with it. The signal indicators are
into the contact block and soldered
matching the lens. The LEDs are fitted
superbright 3 mm LEDs in the colour
nation, we recommend to use the
as illuminated versions. For illumi-
stop buttons are also available
Illumination
selector switches and emergency
RAFIX 22 FS pushbuttons,
2 - 149
RAFIX
22 FS
2