SW60-361P ALBRIGHT ENGINEERS, SW60-361P Datasheet - Page 3

• Manufacturer Part Number: SW60-361P
• Description: CONTACTOR, C/O, 24VDC
• Manufacturer: ALBRIGHT ENGINEERS

Specifications of SW60-361P

• Operating Voltage: 24V
• Contacts: SPST-NO
• Relay Mounting: Bracket
• Coil Voltage Vdc Nom: 24V
• Svhc: No SVHC (18-Jun-2010)
• Contact Configuration: SPST
• Contact Current Dc Max: 80A
• Contact Voltage Dc Max: 250V

80 Ampere
Miniature
DC Contactors
from...
P C
P C 6 0 / 6 1 / 6 3
PC60A
S E R I E S
Protected Versions
These have closed contact housings, and are
assembled with rubber gaskets to inhibit the
ingress of moisture or other contamination. They
are protected to IP66.
These versions can be washed after soldering to
the board and may be used in dirty or wet
environments.
Washable Contactors with Auxiliary Contacts
PC60A.W, PC61A.W & PC63A.W
Normally the auxiliary contacts are supplied already fitted to the contactor
but if the printed circuit boards are to be washed after soldering, the
auxiliary contact is supplied separately and the contactor is temporarily
sealed with a rubber plug which is removed after washing and the
auxiliary contact is then fitted.
The contactors are not therefore fully protected against the environment to
the same degree as the PC60.P, PC61.P and PC63.P.
Installation
To accommodate the ”PC” contactors, printed circuit boards should be drilled
in accordance with the drawing on page 4.
Prior to soldering, the PC60, PC61 and PC63 can be secured to the circuit board
by means of a M4 bolt which protrudes from the underside of the contactor.
If the full current ratings of the contactors are to be utilised, circuit board
tracks should have the appropriate
thickness and width of copper.
Conventional hand or wave soldering
techniques can be used and if the
circuit board is to be washed the
appropriate PC60.P, PC61.P, PC63.P
or PC60A.W, PC61A.W, PC63A.W
should be specified.
PC60.P, PC61.P & PC63.P
Explanation of Type Numbers
PC60 - A - B - P - W - M
Main type number
With auxiliary contacts
Please note:
Contactors fitted
with auxiliary contacts
cannot be fully protected
against unfriendly
environments.
With magnetic blowouts
Dimensions in mm (inches).
Rubber Gasket Protection
Washable Contactors
Magnetic Latching
3