LP2992IM5-5.0 National Semiconductor, LP2992IM5-5.0 Datasheet - Page 13

Linear Voltage Regulator IC

LP2992IM5-5.0

Manufacturer Part Number
LP2992IM5-5.0
Description
Linear Voltage Regulator IC
Manufacturer
National Semiconductor
Datasheets

Specifications of LP2992IM5-5.0

No. Of Pins
5
Output Current
0.25A
Peak Reflow Compatible (260 C)
No
Supply Voltage
16V
Current Rating
250A
Output Voltage Max
5V
Supply Voltage Max
16V
Leaded Process Compatible
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
LP2992IM5-5.0
Manufacturer:
NS
Quantity:
3
Part Number:
LP2992IM5-5.0
Manufacturer:
NS
Quantity:
9
Part Number:
LP2992IM5-5.0
Manufacturer:
TI
Quantity:
12 500
Part Number:
LP2992IM5-5.0
Manufacturer:
NS/国半
Quantity:
20 000
Application Hints
It should also be noted that the ESR of a typical Tantalum will
increase about 2:1 as the temperature goes from 25˚C down
to −40˚C, so some guard band must be allowed.
ON/OFF INPUT OPERATION
The LP2992 is shut off by driving the ON/OFF input low, and
turned on by pulling it high. If this feature is not to be used,
the ON/OFF input should be tied to V
output on at all times.
To assure proper operation, the signal source used to drive
the ON/OFF input must be able to swing above and below
the specified turn-on/turn-off voltage thresholds listed in the
Electrical Characteristics section under V
mis-operation, the turn-on (and turn-off) voltage signals ap-
plied to the ON/OFF input must have a slew rate which is
≥ 40 mV/µs.
Caution: the regulator output voltage can not be guaranteed
if a slow-moving AC (or DC) signal is applied that is in the
range between the specified turn-on and turn-off voltages
listed under the electrical specification V
cal Characteristics).
REVERSE INPUT-OUTPUT VOLTAGE
The PNP power transistor used as the pass element in the
LP2992 has an inherent diode connected between the regu-
lator output and input. During normal operation (where the
input voltage is higher than the output) this diode is reverse-
biased.
(Continued)
IN
to keep the regulator
ON/OFF
ON/OFF
(see Electri-
. To prevent
13
However, if the output is pulled above the input, this diode
will turn ON and current will flow into the regulator output. In
such cases, a parasitic SCR can latch which will allow a high
current to flow into V
damage the part.
In any application where the output may be pulled above the
input, an external Schottky diode must be connected from
V
reverse voltage across the LP2992 to 0.3V (see Absolute
Maximum Ratings).
LLP MOUNTING
The LLP package requires specific mounting techniques
which are detailed in National Semiconductor Application
Note # 1187. Referring to the section PCB Design Recom-
mendations, it should be noted that the pad style which
should be used with the LLP package is the NSMD (non-
solder mask defined) type.
IN
to V
OUT
(cathode on V
IN
(and out the ground pin), which can
IN
, anode on V
OUT
), to limit the
www.national.com

Related parts for LP2992IM5-5.0