LM75CIM-5 National Semiconductor, LM75CIM-5 Datasheet - Page 6

• Manufacturer Part Number: LM75CIM-5
• Description: Temperature Sensor IC
• Manufacturer: National Semiconductor

Specifications of LM75CIM-5

• Mounting Type: Surface Mount
• Supply Voltage Min: 3V
• Operating Temperature Max: 125°C
• Peak Reflow Compatible (260 C): No
• Ic Function: Temperature Sensor IC
• Supply Voltage Max: 5.5V
• Leaded Process Compatible: No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

www.national.com
Note 5: LM75 θ
in the table below:
Note 6: All part numbers of the LM75 will operate properly over the +V
at their nominal supply voltage. Accuracy will typically degrade 1˚C/V of variation in +V
Note 7: Limits are guaranteed to National’s AOQL (Average Outgoing Quality Level).
Note 8: This specification is provided only to indicate how often temperature data is updated. The LM75 can be read at any time without regard to conversion state
(and will yield last conversion result). If a conversion is in process it will be interrupted and restarted after the end of the read.
Note 9: For best accuracy, minimize output loading. Higher sink currents can affect sensor accuracy with internal heating. This can cause an error of 0.64˚C at full
rated sink current and saturation voltage based on junction-to-ambient thermal resistance.
Note 10: O.S. Delay is user programmable up to 6 “over limit” conversions before O.S. is set to minimize false tripping in noisy environments.
Note 11: Default values set at power up.
Note 12: Typicals are at T
Note 13: Holding the SDA line low for a time greater than t
High).
LM75BIMM-3, LM75BIMM-5, LM75CIMM-3, LM75CIMM-5
LM75BIM-3, LM75BIM-5, LM75CIM-3, LM75CIM-5
JA
(thermal resistance, junction-to-ambient) when attached to a printed circuit board with 2 oz. foil similar to the one shown in Figure 3 is summarized
FIGURE 2. Temperature-to-Digital Transfer Function (Non-linear scale for clarity)
A
= 25˚C and represent most likely parametric norm.
Device Number
TIMEOUT
will cause the LM75B to reset SDA to the IDLE state of the serial bus communication (SDA set
S
supply voltage range of 3V to 5.5V. The devices are tested and specified for rated accuracy
6
S
as it varies from the nominal value.
NS Package
MUA08A
Number
M08A
01265805
Resistance (θ
200˚C/W
250˚C/W
Thermal
JA
)