LM336M-5.0 National Semiconductor, LM336M-5.0 Datasheet - Page 5

• Manufacturer Part Number: LM336M-5.0
• Description: Voltage Reference
• Manufacturer: National Semiconductor

Specifications of LM336M-5.0

• Peak Reflow Compatible (260 C): No
• Current Rating: 10A
• Leaded Process Compatible: No
• Mounting Type: Surface Mount
• Supply Current: 600mA
• Package / Case: 8-NSOIC
• Fixed / Adjust / Prog: Precision
• Output Voltage (max): 5V
• Reference Voltage Accuracy (max): 1
• Load Regulation: 20mV
• Operating Temp Range: 0C to 70C
• Operating Temperature Classification: Commercial
• Mounting: Surface Mount
• Pin Count: 8
• Package Type: SOIC N
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Forward Characteristics
571623
Breakdown Voltage (Trim Range = ±1.0V Typical)
Application Hints
The LM136-5.0 series voltage references are much easier to
use than ordinary zener diodes. Their low impedance and
wide operating current range simplify biasing in almost any
circuit. Further, either the breakdown voltage or the temper-
ature coefficient can be adjusted to optimize circuit perfor-
mance.
Figure 1 shows an LM136-5.0 with a 10k potentiometer for
adjusting the reverse breakdown voltage. With the addition of
R1 the breakdown voltage can be adjusted without affecting
the temperature coefficient of the device. The adjustment
range is usually sufficient to adjust for both the initial device
tolerance and inaccuracies in buffer circuitry.
If minimum temperature coefficient is desired, four diodes can
be added in series with the adjustment potentiometer as
shown in Figure 2. When the device is adjusted to 5.00V the
temperature coefficient is minimized. Almost any silicon sig-
nal diode can be used for this purpose such as a 1N914,
1N4148 or a 1N457. For proper temperature compensation
the diodes should be in the same thermal environment as the
LM136-5.0. It is usually sufficient to mount the diodes near
the LM136-5.0 on the printed circuit board. The absolute re-
571610
sistance of the network is not critical and any value from 2k
FIGURE 2. Temperature Coefficient Adjustment
to 20k will work. Because of the wide adjustment range, fixed
(Trim Range = ±0.5V Typical)
resistors should be connected in series with the pot to make
pot setting less critical.
571609
FIGURE 1. LM136-5.0 with Pot for Adjustment of
5
www.national.com