LM2673S-5.0 National Semiconductor, LM2673S-5.0 Datasheet - Page 14

• Manufacturer Part Number: LM2673S-5.0
• Description: DC/DC Converter IC
• Manufacturer: National Semiconductor

Specifications of LM2673S-5.0

• Input Voltage: 40V
• Output Current: 3A
• Output Voltage: 5V
• No. Of Pins: 7
• Termination Type: SMD
• Mounting Type: Through Hole
• Voltage Regulator Type: Switching
• Output Current Max: 3A
• Peak Reflow Compatible (260 C): No
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

www.national.com
Application Hints
The switching frequency of 260KHz is the nominal value to
use to estimate the ON time of the switch during which
energy is stored in the inductor.
For this example E • T is found to be:
Using Figure 6, the intersection of 27V • µS horizontally and
the 2A vertical line (I
inductor, should be used.
From Table 1, L38 in a surface mount component is available
from Pulse Engineering with part number PE-54038S.
Step 4: Use Table 6 to determine an output capacitor. With a
14.8V output the 12.5 to 15V row is used and with a 68µH
inductor there are three surface mount output capacitor so-
lutions. Table 2 provides the actual capacitor characteristics
based on the C Code number. Any of the following choices
can be used:
1 x 33µF/20V AVX TPS (code C6)
1 x 47µF/20V Sprague 594 (code C8)
1 x 47µF/20V Kemet T495 (code C8)
Important Note: When using the adjustable device in low
voltage applications (less than 3V output), if the nomograph,
Figure 6, selects an inductance of 22µH or less, Table 6 does
not provide an output capacitor solution. With these condi-
tions the number of output capacitors required for stable
operation becomes impractical. It is recommended to use
either a 33µH or 47µH inductor and the output capacitors
from Table 6.
load
max) indicates that L38 , a 68µH
(Continued)
14
Step 5: An input capacitor for this example will require at
least a 35V WV rating with an rms current rating of 1A (1/2
Iout max). From Table 2 it can be seen that C12, a 33µF/35V
capacitor from Sprague, has the required voltage/current
rating of the surface mount components.
Step 6: From Table 5 a 3A Schottky diode must be selected.
For surface mount diodes with a margin of safety on the
voltage rating one of five diodes can be used:
SK34
30BQ040
30WQ04F
MBRS340
MBRD340
Step 7: A 0.01µF capacitor will be used for Cboost.
The softstart pin will be left open circuited.
Step 8: Determine a value for R
current limit of at least 2A plus 50% or 3A.
Use a value of 12.4KΩ.
LLP PACKAGE DEVICES
The LM2673 is offered in the 14 lead LLP surface mount
package to allow for a significantly decreased footprint with
equivalent power dissipation compared to the TO-263. For
details on mounting and soldering specifications, refer to
Application Note AN-1187.
ADJ
to provide a peak switch