CS5524-AS Cirrus Logic Inc, CS5524-AS Datasheet - Page 34

• Manufacturer Part Number: CS5524-AS
• Description: A/D Converter (A-D) IC
• Manufacturer: Cirrus Logic Inc

Specifications of CS5524-AS

• Sample Rate: 606SPS
• Input Channels Per Adc: 4
• Mounting Type: Surface Mount
• No. Of Channels: 4
• Power Rating: 9mW
• Peak Reflow Compatible (260 C): No
• Supply Voltage Max: 5.25V
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

The variables are defined below.
2.3.3 Calibration Tips
Calibration steps are performed at the output word
rate selected by the WR2-WR0 bits of the configu-
ration register. Since higher word rates result in
conversion words with more peak-to-peak noise,
calibration should be performed at lower output
word rates. Also, to minimize digital noise near
the device, the user should wait for each calibration
step to be completed before reading or writing to
the serial port.
For maximum accuracy, calibrations should be per-
formed for offset and gain (selected by changing
the G2-G0 bits of the desired Setup). Note that only
one gain range can be calibrated per physical chan-
nel. If factory calibration of the user’s system is
performed using the system calibration capabilities
of the CS5521/22/23/24/28, the offset and gain reg-
ister contents can be read by the system microcon-
troller and recorded in EEPROM. These same
calibration words can then be uploaded into the off-
set and gain registers of the converter when power
is first applied to the system, or when the gain range
is changed.
34
V0
V1
Ru
Ru0 =
Ru1
Rc
Rc0
Rc1
Co
Cg
=
=
=
=
=
=
=
=
= Result of uncalibrated conversion of V1
Second calibration voltage (greater than V0)
Result of any uncalibrated conversion
Result of uncalibrated conversion V0
(24-bit integer or 2’s complement)
(24-bit integer or 2’s complement)
Result of any conversion
Desired calibrated result of converting V0
(24-bit integer or 2’s complement)
Desired calibrated result of converting V1
(24-bit integer or 2’s complement)
Gain calibration register value
(24-bit integer)
First calibration voltage
Offset calibration register value
(24-bit 2’s complement)
2.3.4 Limitations in Calibration Range
System calibration can be limited by signal head-
room in the analog signal path inside the chip as
discussed under the Analog Input section of this
data sheet. For gain calibration the full scale input
signal can be reduced to the point in which the gain
register reaches its upper limit of (4-2
or FFFFFF (hexadecimal). Under nominal condi-
tions, this occurs with a full scale input signal equal
to about 1/4 the nominal full scale. With the con-
verter’s intrinsic gain error, this full scale input sig-
nal may be higher or lower. In defining the
minimum Full Scale Calibration Range (FSCR)
under ANALOG CHARACTERISTICS, margin is
retained to accommodate the intrinsic gain error.
Alternatively the input full scale signal can be in-
creased to a point in which the modulator reaches
its 1’s density limit of 80 percent, which under
nominal condition occurs when the full scale input
signal is 1.5 times the nominal full scale. With the
chip’s intrinsic gain error, this full scale input sig-
nal may be higher or lower. In defining the maxi-
mum FSCR, margin is again incorporated to
accommodate the intrinsic gain error. In addition,
for full scale inputs greater than the nominal full
scale value of the range selected, there is some volt-
age at which various internal circuits may saturate
due to limited amplifier headroom. This is most
likely to occur in the 100 mV range.
2.4 Performing Conversions and Reading
the Data Conversion FIFO
The CS5521/22/23/24/28 offers various modes of
performing conversions. The sections that follow
detail the differences between the conversion
modes. The sections also provide examples illus-
trating how to use the conversion modes with the
channel-setup registers and to acquire conversions
for further processing. While reading, note that the
CS5521/22 have a FIFO which is four words deep.
The CS5523/24 have a FIFO which is eight words
deep and the CS5528 has a FIFO which is sixteen
CS5521/22/23/24/28
-22
DS317F2
decimal)