S-5814A-I4T1G Seiko Instruments, S-5814A-I4T1G Datasheet - Page 12

• Manufacturer Part Number: S-5814A-I4T1G
• Description: IC, TEMP SENSOR, ± 2.5°C, SNT-4A-4
• Manufacturer: Seiko Instruments

Specifications of S-5814A-I4T1G

• Ic Output Type: Voltage
• Sensing Accuracy Range: ± 2.5°C
• Supply Current: 4µA
• Supply Voltage Range: 2.4V To 10V
• Sensor Case Style: SNT-4A
• No. Of Pins: 4
• Operating Temperature Range: -40°C To +100°C
• Full Temp Accuracy: +/- 2.5 C
• Package / Case: SNT-4A
• Supply Voltage (max): 10 V
• Supply Voltage (min): 2.4 V
• Maximum Operating Temperature: + 100 C
• Minimum Operating Temperature: - 40 C
• Rohs Compliant: Yes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

12
CMOS TEMPERATURE SENSOR IC
S-5813A/14A/15A/16A Series
• Wiring patterns for the VDD pin, VOUT pin, and VSS pin should be designed to hold low impedance.
• In this IC, if load capacitance of the VOUT pin is large, VOUT pin voltage may oscillate. It is recommended not to use the
• Please do not connect a pull-up resistor to the output voltage pin.
• The application condition for input voltage, output voltage and load voltage must not exceed the package power
• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in electrostatic
• SII claims no responsibility for any disputes arising out of or in connection with any infringement by products including this
• The side of device silicon substrate is exposed to the marking side of device package. Since this portion has lower
• In this package, the overcoat of the resin of translucence is carried out on the side of device area. Keep it mind that it may
Precautions
Precautions for WLP package
external capacitor between the VOUT and VSS pin. When using an external capacitor, mount it near the VOUT pin.
When connecting an A/D converter etc. to the VOUT pin, the input pin capacitance of the A/D converter and the parasitic
To prevent oscillation, it is recommended to use the following output load condition.
dissipation.
protection circuit.
IC of patents owned by a third party.
strength against the mechanical stress than the standard plastic package, chip, crack, etc should be careful of the
handing of a package enough. Moreover, the exposed side of silicon has electrical potential of device substrate, and
needs to be kept out of contact with the external potential.
affect the characteristic of a device when exposed a device in the bottom of a high light source.
capacitance component between wires are included as load capacitance.
Caution The above connection diagram and constant will not guarantee successful operation. Perform
Load capacitance of VOUT pin (C
through evaluation using the actual application to set the constant.
VDD
C
IN
L
) : 2.2 μF or less
Seiko Instruments Inc.
15A/16A Series
S-5813A/14A/
VSS
Figure 11
VOUT
C
L
V
OUT
Rev.3.0
_00