S-1206B18-M3T1G Seiko Instruments, S-1206B18-M3T1G Datasheet - Page 13

• Manufacturer Part Number: S-1206B18-M3T1G
• Description: IC, LDO VOLT REG, 1.8V, 250mA, 3-SOT-23
• Manufacturer: Seiko Instruments

Specifications of S-1206B18-M3T1G

• Primary Input Voltage: 6.5V
• Output Voltage Fixed: 1.8V
• Dropout Voltage Vdo: 150mV
• No. Of Pins: 3
• Output Current: 250mA
• Operating Temperature Range: -40°C To +85°C
• Output Voltage: 5.2V
• Polarity: Positive
• Input Voltage Max: 7 V
• Output Type: Fixed
• Dropout Voltage (max): 3 V at 100 mA
• Load Regulation: 20 mV
• Voltage Regulation Accuracy: 1 %
• Maximum Power Dissipation: 430 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SOT-23
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Rev.3.0
Precautions
• Wiring patterns for the VIN pin, VOUT pin and GND pin should be designed so that the impedance is low. When
• Note that the output voltage may generally increase when a series regulator is used at low load current (10 μA or less).
• Note that the output voltage may generally increase due to driver leakage when a series regulator is used at high
• The voltage regulator may oscillate when the impedance of the power supply is high and the input capacitance is small
• If the output capacitance is small, the power supply fluctuation and load fluctuation characteristics become worse.
• If the power supply suddenly increases sharply when the output capacitance is small, a momentary overshoot may be
• The application conditions for the input voltage, output voltage, and load current should not exceed the package power
• Do not apply an electrostatic discharge to this IC that exceeds the performance ratings of the built-in electrostatic
• In determining the output current, attention should be paid to the output current value specified in Table 6 in “
• SII claims no responsibility for any disputes arising out of or in connection with any infringement by products including
• Generally a series regulator may cause oscillation, depending on the selection of external parts. The following
ULTRA LOW CURRENT CONSUMPTION AND LOW DROPOUT CMOS VOLTAGE REGULATOR
mounting an output capacitor between the VOUT pin and VSS pin (C
the VIN pin and VSS pin (C
temperatures.
Use an I/O capacitor with good temperature characteristics (conforming to the ceramic capacitor EIA X5R (JIS B)
characteristics).
or an input capacitor is not connected.
Sufficiently evaluate the output voltage fluctuation with the actual device.
output. It is therefore important to sufficiently evaluate the output voltage at power application in the actual device.
dissipation.
protection circuit.
Electrical Characteristics” and footnote *5 of the table.
this IC of patents owned by a third party.
conditions are recommended for this IC. However, be sure to perform sufficient evaluation under the actual usage
conditions for selection, including evaluation of temperature characteristics.
(R
Example (Ta = 25°C) in “ Reference Data”.
ESR
Input capacitor (C
Output capacitor (C
) of the output capacitor, refer to (5) Equivalent Series Resistance vs. Output Current Characteristics
_00
IN
) :
L
) :
IN
), the distance from the capacitors to these pins should be as short as possible.
0.1 μF or more
0.1 μF or more
Seiko Instruments Inc.
L
) and a capacitor for stabilizing the input between
For the equivalent series resistance
S-1206 Series
13