S-1206B18-I6T2G Seiko Instruments, S-1206B18-I6T2G Datasheet - Page 9

• Manufacturer Part Number: S-1206B18-I6T2G
• Description: IC, LDO VOLT REG, 1.8V, 250mA, SNT-6A-6
• Manufacturer: Seiko Instruments

Specifications of S-1206B18-I6T2G

• Primary Input Voltage: 6.5V
• Output Voltage Fixed: 1.8V
• Dropout Voltage Vdo: 150mV
• No. Of Pins: 6
• Output Current: 250mA
• Operating Temperature Range: -40°C To +85°C
• Output Voltage: 5.2V
• Polarity: Positive
• Input Voltage Max: 7 V
• Output Type: Fixed
• Dropout Voltage (max): 3 V at 100 mA
• Load Regulation: 20 mV
• Voltage Regulation Accuracy: 1 %
• Maximum Power Dissipation: 500 mW
• Maximum Operating Temperature: + 85 C
• Mounting Style: SMD/SMT
• Package / Case: SNT-6A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Rev.1.1
Standard Circuit
Application Conditions
Selection of Input Capacitor (C
Caution
Input capacitor (C
Output capacitor (C
Caution A general series regulator may oscillate, depending on the external components selected. Check that
The S-1206 Series requires an output capacitor between the VOUT pin and VSS pin for phase compensation.
Operation is stabilized by a ceramic capacitor with an output capacitance of 0.1 µF or more in the entire temperature
range. However, when using an OS capacitor, tantalum capacitor, or aluminum electrolytic capacitor with a capacitance
of 0.1 µF or more less is required.
The value of the output overshoot or undershoot transient response varies depending on the value of the output
capacitor.
The required capacitance of the input capacitor differs depending on the application.
The recommended value for an application is 0.1 µF or more for C
these capacitors, perform sufficient evaluation, including evaluation of temperature characteristics, on the actual device.
ULTRA LOW CURRENT CONSUMPTION AND LOW DROPOUT CMOS VOLTAGE REGULATOR
_00
no oscillation occurs in the actual device using the above capacitor.
The above connection diagram and constant will not guarantee successful operation.
thorough evaluation using the actual application to set the constant.
IN
) : 0.1 µF or more
L
) : 0.1 µF or more (ceramic capacitor)
*1. A capacitor for stabilizing the input.
*2. A ceramic capacitor of 0.1 µF or more can be used.
C
IN
Input
*1
IN
) and Output Capacitor (C
Seiko Instruments Inc.
Single GND
VIN
Figure 9
VSS
VOUT
IN
and 0.1 µF or more for C
Output
GND
C
L
*2
L
)
L
; however, when selecting
S-1206 Series
Perform
9