LM2577T-ADJ National Semiconductor, LM2577T-ADJ Datasheet - Page 15

no-image

LM2577T-ADJ

Manufacturer Part Number
LM2577T-ADJ
Description
IC, STEP-UP VOLTAGE REGULATOR, TO-220-5
Manufacturer
National Semiconductor
Datasheets

Specifications of LM2577T-ADJ

Primary Input Voltage
40V
No. Of Outputs
1
Output Voltage
12V
Output Current
3A
No. Of Pins
5
Operating Temperature Range
-40°C To +125°C
Peak Reflow Compatible (260 C)
No
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
LM2577T-ADJ
Manufacturer:
VISHAY
Quantity:
40 000
Part Number:
LM2577T-ADJ
Manufacturer:
NS
Quantity:
76
Part Number:
LM2577T-ADJ
Manufacturer:
NS
Quantity:
5 510
Part Number:
LM2577T-ADJ
Manufacturer:
NS
Quantity:
56
Part Number:
LM2577T-ADJ
Manufacturer:
ST
0
Part Number:
LM2577T-ADJ
Manufacturer:
NS/国半
Quantity:
20 000
Company:
Part Number:
LM2577T-ADJ
Quantity:
25 000
Part Number:
LM2577T-ADJ/NOPB
Manufacturer:
TOSHIBA
Quantity:
7 600
Application Hints
Note: These charts assume that the inductor ripple current inductor is approximately 20% to 30% of the average inductor current (when the regulator is under
full load). Greater ripple current causes higher peak switch currents and greater output ripple voltage; lower ripple current is achieved with larger-value
inductors. The factor of 20 to 30% is chosen as a convenient balance between the two extremes.
C. Select an inductor from the table of Figure 10 which
cross-references the inductor codes to the part numbers
of three different manufacturers. Complete specifica-
tions for these inductors are available from the respec-
tive manufacturers. The inductors listed in this table
have the following characteristics:
AIE: ferrite, pot-core inductors; Benefits of this type are
low electro-magnetic interference (EMI), small physical
size, and very low power dissipation (core loss). Be
careful not to operate these inductors too far beyond
their maximum ratings for E • T and peak current, as this
will saturate the core.
Pulse: powdered iron, toroid core inductors; Benefits are
low EMI and ability to withstand E • T and peak current
above rated value better than ferrite cores.
Renco: ferrite, bobbin-core inductors; Benefits are low
cost and best ability to withstand E • T and peak current
above rated value. Be aware that these inductors gener-
ate more EMI than the other types, and this may inter-
fere with signals sensitive to noise.
FIGURE 9. LM1577-ADJ/LM2577-ADJ Inductor Selection Graph
(Continued)
15
DS011468-12
www.national.com

Related parts for LM2577T-ADJ