MB95F264KPF-G-SNE2 Fujitsu, MB95F264KPF-G-SNE2 Datasheet - Page 47

• Manufacturer Part Number: MB95F264KPF-G-SNE2
• Description: MCU, 8BIT, 20K FLASH, 8FX, 20SOP
• Manufacturer: Fujitsu

Specifications of MB95F264KPF-G-SNE2

• No. Of I/o's: 17
• Ram Memory Size: 496Byte
• Cpu Speed: 16.25MHz
• No. Of Timers: 1
• No. Of Pwm Channels: 2
• Core Size: 8bit
• Program Memory Size: 20KB
• Oscillator Type: Internal, External
• Controller Family/series: MB95260H

(Continued)
*1: The parameter is based on V
*2: V
*3: Applicable to the following pins: P00 to P07, P62 to P64, PG1, PG2, PF0, PF1 (P00, P62, P63 and P64 are
*4: P62 and P63 are available only in MB95F262H/F262K/F263H/F263K/F264H/F264K.
WARNING: Semiconductor devices can be permanently damaged by application of stress (voltage, current,
DS07–12627–6E
current to/from an input is limited by means of an external component, the I
the V
available only in MB95F262H/F262K/F263H/F263K/F264H/F264K. P01, P02, P03, P07, PG1, PG2, PF0
and PF1 are available only in MB95F262H/F262K/F263H/F263K/F264H/F264K/F282H/F282K/F283H/
F283K/F284H/F284K.)
• Use under recommended operating conditions.
• Use with DC voltage (current).
• The HV (High Voltage) signal is an input signal exceeding the V
• The value of the limiting resistor should be set to a value at which the current to be input to the microcontroller
• When the microcontroller drive current is low, such as in low power consumption modes, the HV (High
• If the HV (High Voltage) signal is input when the microcontroller power supply is off (not fixed at 0 V), since
• If the HV (High Voltage) input is input after power-on, since power is supplied from the pins, the voltage
• Do not leave the HV (High Voltage) input pin unconnected.
• Example of a recommended circuit:
I
between the HV (High Voltage) signal and the microcontroller before applying the HV (High Voltage) signal.
pin when the HV (High Voltage) signal is input is below the standard value, irrespective of whether the
current is transient current or stationary current.
Voltage) input potential may pass through the protective diode to increase the potential of the V
affecting other devices.
power is supplied from the pins, incomplete operations may be executed.
of power supply may not be sufficient to enable a power-on reset.
and V
I
rating.
O
temperature, etc.) in excess of absolute maximum ratings. Do not exceed these ratings.
must not exceed V
• Input/Output equivalent circuit
SS
CC
HV(High Voltage) input (0 V to 16 V)
= 0.0 V.
+ 0.3 V. V
MB95260H/270H/280H Series
I
must not exceed the rated voltage. However, if the maximum
Limiting
resistor
CC
voltage. Always connect a limiting resistor
CLAMP
rating is used instead of
Protective diode
R
V
CC
P-ch
N-ch
CC
pin,
47