87421-0000 Molex Inc, 87421-0000 Datasheet - Page 4

• Manufacturer Part Number: 87421-0000
• Description: CONTACT, FEMALE, 30-24AWG, CRIMP
• Manufacturer: Molex Inc
• Series: Pico-SPOXr

Specifications of 87421-0000

• Connector Type: Wire To Board Contact
• Current Rating: 3A
• Contact Plating: Tin
• Contact Material: Phosphor Bronze
• Product Type: Contacts
• Contact Gender: Socket (Female)
• Pitch: 1.5 mm
• Mounting Style: Wire
• Termination Style: Crimp
• Wire Gauge Range: 30-24
• Voltage Rating: 50 V
• Wire Size (awg): 30-24
• For Use With: 87439 Pico-SPOX Wire-to-Board Housings
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Document Revision Level: A
Doc. No. 638113600 Document Release date: 02-07-08
Maintenance
Miscrimps or Jams (see Fig. 1)
How To Adjust Tool Crimp Force (see Fig. 1)
Warranty
3. Make certain all pins, pivot points and bearing surfaces are protected with a thin coat of high quality
4. When tool is not in use, keep the handles closed to prevent objects from becoming lodged in the crimping
It is recommended that each operator of the tool be made aware of , and responsible for, the
following maintenance steps:
1. Remove dust, moisture and other contaminants with a clean brush, or soft, lint free cloth.
2. Do not use any abrasive materials that could damage the tool.
Should this tool ever become stuck or jammed in a partially closed position, Do Not force the handles open
or closed. The tool will open easily by lifting the ratchet release lever.
This tool is for electrical terminal crimping purposes only. This tool is made of the best quality materials. All vital
components are long life tested. All tools are warrantied to be free of manufacturing defects for a period of 30 days.
Should such a defect occur, we will exchange the tool free of charge. This exchange will not be applicable to altered,
misused, or damaged tools. This tool is designed for hand use only. Any clamping, fixturing, or use of handle extensions
voids this warranty.
1. Remove the screw and washer. Located over the adjustment ring.
2. Lift the adjusting ring slightly, off of the locating pin.
4. Press the adjusting wheel flat against the tool and engage the locking pin.
5. Replace the washer and screw.
6. Check the crimp specifications after tool crimp force is adjusted.
3. Turn the adjusting ring in the desired direction (L= less force, T= more force) to increase or decrease crimp pressure.
It may be necessary over the life of the tool to adjust tool crimping force. Listed below are the steps
required to adjust the crimping force of the handtool to obtain proper crimp conditions:
machine oil. Do not oil excessively.
dies, and store the tool in a clean, dry area.
Revision Date: 02-07-08 UC2002-0009
tel: [phone]
Molex Application Tooling Group
Naperville, Il. 60563
1150 E. Diehl Rd.
fax: [phone]
Uncontrolled Copy
Page 4 of 4