W12S-P012 DEUTSCH, W12S-P012 Datasheet - Page 10
![no-image](/images/no-image-200.jpg)
W12S-P012
Manufacturer Part Number
W12S-P012
Description
WEDGELOCK, FOR DT PLUGS, 12WAY
Manufacturer
DEUTSCH
Series
DTr
Datasheet
1.61031-23.pdf
(12 pages)
Specifications of W12S-P012
Svhc
No SVHC (15-Dec-2010)
No. Of Contacts
12
Accessory Type
Dust Cap
For Use With
Deutsch's DT Series
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
How to Crimp
with the HDT48-00 Hand Tool
Step 1:
Step 2:
Step 3:
Step 4:
Step 5:
Step 6:
Step 7:
Strip insulation from wire.
Please refer to the instructions ‘How to Strip a Wire for the HDT48-00 Crimp
Tool’ on page 9.
Raise selector knob and rotate until arrow is aligned with wire gauge to be
crimped. (A).
Loosen lock nut, turn adjusting screw in until it stops. (B).
Insert contact (See C for insertion point), turn adjusting screw clockwise out
until contact is flush or a bit above flush with indentor cover. Tighten lock
nut.
Insert wire in contact (D). Contact must be centered between indicators.
Close handles until the handles stop.
Release handles and remove crimped contact.
When completed, correct assembly can be checked visually. The removed
insulation should expose a conductor length that will pass beyond the
inspection hole in the contact. There should be about .025” to .100” of
conductor between the contact and the insulation of the wire.
The following should be checked for after crimping:
1.
2.
3.
4.
If any of the above conditions exist, please discard the contact, re-cut and
strip the wire and start the crimping process over.
.025 - .100 (.63 - 2.54)
Insulation Gap
Damaged wire strands.
Missing wire strands.
Wire strands not entering the contact barrel or splayed wires.
Wire not inserted to the correct depth in the contact, i.e. not visible
through inspection hole.
Correct Crimp
Crimp centered between the
inspection hole and crimp barrel end
Conductor strands must be
visible through the
inspection hole
10
Insertion Point
A
C
D
B
Lock Nut
Adjusting Screw