BNC230 IDEC, BNC230 Datasheet - Page 8

• Manufacturer Part Number: BNC230
• Description: DUST COVER, POLYCARBONATE
• Manufacturer: IDEC

Specifications of BNC230

• Connector Body Material: Polycarbonate
• Enclosure Material: Polycarbonate
• Accessory Type: Dust Cover
• For Use With: BNH/BN Terminal Blocks
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

www.idec.com
Step 1. Insert the wire (or crimping terminal) into
Step 2. Push the terminal screw down to hold the
Step 3. Hold the terminal screw down, and tighten
Step 4. To remove the wire, loosen the terminal
Step 1. Slide the terminal blocks onto the DIN rail from one end.
Step 2. Use BNL5 or BNL6 end clips to secure the terminal block row
Step 3. To install, place the terminal block on top of the DIN rail and
Step 4. To remove the terminal block, use the BND2 removal tool as
DIN Rail Mount:
Step 1. First install the end plate. Then mount the terminal blocks onto
Step 2. To prevent side-to-side movement on the DIN rail, use the BNL-8
Panel Mount:
Step 1. Assemble a row of terminal blocks with end plates on exposed
Step 2. Use BNDL2 mounting clips at both ends of a row.
Step 3. With the two holes of the mounting clip aligned with the terminal
Step 4. Secure the ends of the connecting rods with the connecting
end(s).
block holes, insert a connecting rod through each hole.
nuts, as shown below.
the terminal block with the terminal
screws in the open position. (Use of
crimping terminals is optional.)
wire in place.
with a screwdriver.
screw and pull up until wire is released.
and to prevent side-to-side movement. BNH10W, BNH15MW,
BNH15LW, and BNH30W can be installed from the middle of a
DIN rail.
push down until both edges of the terminal block snap onto the
DIN rail.
shown on the right.
the DIN rail.
mounting clip at both ends of the rail.
Instructions
Terminal Blocks
Instructions
Instructions
USA: (800) 262-IDEC or [phone], Canada: (888) 317-IDEC
Wiring Touch-Down Terminal Blocks: BNH Series
Installation and Removal of Terminal Blocks
Mounting Double-Deck Terminal Blocks
Step 1
Instructions
Connecting
Mounting
Nut (hex)
Clip
Plate
Step 2
End
Connecting
Rod
Appearance
Appearance
Terminal
Block
Step 3
Removal
Tool
BND2
Mounting
Clip
Instructions
Step 4
Connecting
Nut (round)
P-17
P