PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- - use, production operations is available.
} Contact the Tooling Assistance Center or Product Information (at the numbers listed below) for specific receptacle part numbers.
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool Assembly
58628--1 consists of Die Assembly 58628--2 and
PRO--CRIMPER III Hand Crimping Tool Frame
354940--1. The tool is used to crimp the receptacles
onto the wire sizes listed in Figure 1.
Read these instructions thoroughly before crimping
E2009 Tyco Electronics Corporation, Harrisburg, PA
All International Rights Reserved
TE logo and Tyco Electronics are trademarks.
*Trademark. Other products, logos, and company names used are the property of their respective owners.
The PRO- - CRIMPER III Hand Crimping Tool Assembly is a “Commercial”
grade tool and is designed primarily for field installation, repair, maintenance
work, or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement for hand
tools in the appropriate 114 series specification, but may not comply with other
feature parameters of the specification. Tyco Electronics offers a variety of
tools to satisfy your performance requirements. For additional information,
contact the Tooling Assistance Center at 1- - 800- - 722- - 1111.
Assembly
Assembly
58628--2
TE Die
Ultra--Fast FASTON*
Straight Receptacle
Straight Receptacle
Product
Family}
Family}
Die Assembly
Front of Tool
Moving Jaw
TOOLING ASSISTANCE CENTER 1- - 800- - 722- - 1111
PRODUCT INFORMATION 1- - 800- - 522- - 6752
PRO- CRIMPER* III Hand Crimping
Tool Assembly 58628- 1 with
Die Assembly 58628- 2
(AWG)
26--22
22--18
16--14
Size
Size
Ratchet Adjustment
Wheel
Standard
2.54 [.100]
3.05 [.120]
Figure 1
—
110 and 125
Insulation Diameter (Max) (mm [in.])
any receptacles.
If these instructions are revised, reasons for revison
will be listed in Section 9, REVISION SUMMARY.
for Receptacle Series Size
NOTE
5.84 [.230]
6.60 [.260]
Large
i
—
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
are for identification only and are not drawn to
scale.
Wire
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.tycoelectronics.com
Stationary Jaw
3.43 [.135]
4.06 [.160]
Standard
—
187 and 250
Pivot Pin
Back of Tool
(Wire Side)
5.84 [.230]
6.60 [.260]
Large
PRO- - CRIMPER III Hand
Crimping Tool Frame
354940- - 1 (408- - 9930)
Moving
Handle
—
Instruction Sheet
408- - 4452
22 JUN 09 Rev A
Stationary
Handle
Strip Length
Strip Length
[ 281+ 016]
[.281+.016]
(mm [in.])
7.14+0.41
1 of 4
LOC B