RN-174 Roving Networks Inc, RN-174 Datasheet - Page 7

• Manufacturer Part Number: RN-174
• Description: RF EVAL GSX SUPER MODULE
• Manufacturer: Roving Networks Inc
• Type: Transceiver, 802.11 b/gr

Specifications of RN-174

• Frequency: 2.402GHz ~ 2.48GHz
• Wireless Frequency: 2402 MHz to 2480 MHz
• Interface Type: RS-232, SPI, UART
• Modulation: DSSS, OFDM
• Security: 128 bit WEP, AES, TKIP
• Operating Voltage: 3.3 V
• Output Power: 12 dBm
• Operating Temperature Range: - 40 C to + 85 C
• Board Size: 1950 mm x 1105 mm
• Antenna: Supports Chip, PCB Trace, Wire, U.FL Connector for External
• For Use With/related Products: RN-171
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: 740-1040

4. Adhoc and Restoring Factory Settings. Jumper J6 on the jumper header is connected to GPIO9. When this
Ordering Information
* For these non-standard configurations, please contact Roving Networks directly at
[e-mail]
Roving Networks reserves the right to make corrections, modifications, and other changes to its products,
documentation and services at any time. Customers should obtain the latest relevant information before placing
orders and should verify that such information is current and complete.
Roving Networks assumes no liability for applications assistance or customer product design. Customers are
responsible for their products and applications using Roving Networks components. To minimize the risks associated
with customer products and applications, customers should provide adequate design and operating safeguards.
Roving Networks products are not authorized for use in safety-critical applications (such as life support) where a
failure of the Roving Networks product would reasonably be expected to cause severe personal injury or death,
unless officers of the parties have executed an agreement specifically governing such use.
All other trademarks are property of their respective owners.
Visit
RN-UFL-SMA6
jumper is in place the module will power up in adhoc mode. . If the jumper is then toggled 5 times, the initial
factory default configuration will be RESTORED. This is useful for cases where the module is mis-configured and
is no long responding.
RN-SMA4-RP
Part Number
RN-174-W
RN-174-P
RN-174-U
RN-174-C
RN-174-K
www.rovingnetworks.com
http://www.rovingnetworks.com
809 University Avenue
RN-174 board with PCB trace antenna, standard firmware
RN-174 board with wire antenna*, standard firmware
RN-174 board with U.FL. connector*, standard firmware
RN-174 board with chip antenna*, standard firmware
Development Kit (Includes the RN-174 board and accessory cables)
6 inch cable with U.FL connector on one end and SMA on the other
4” external antenna with reverse polarity SMA connector. Used with RN-UFL-SMA6
Copyright © 2011 Roving Networks. All rights reserved.
For other configurations, contact Roving Networks directly.
•
Los Gatos, CA 95032
for current pricing and a list of distributors carrying our products.
~ page 7 ~
•
Tel [phone]
Description
• [e-mail]
rn-174-ds v1.1 6/1/2011
RN-174