FT2232HQ-REEL FTDI, FT2232HQ-REEL Datasheet - Page 29

• Manufacturer Part Number: FT2232HQ-REEL
• Description: USB Interface IC USB HS to Dual UART/ FIFO/SPI/JTAG/I2C
• Manufacturer: FTDI

Specifications of FT2232HQ-REEL

• Mounting Style: SMD/SMT
• Package / Case: QFN
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

4.6 MPSSE Interface Mode Description.
MPSSE Mode is designed to allow the FT2232H to interface efficiently with synchronous serial protocols
such as JTAG, I2C and SPI Bus. It can also be used to program SRAM based FPGA‟s over USB. The
MPSSE interface is designed to be flexible so that it can be configured to allow any synchronous serial
protocol (industry standard or proprietary) to be implemented using the FT2232H. MPSSE is available on
channel A and channel B.
MPSSE is fully configurable, and is programmed by sending commands down the data stream. These can
be sent individually or more efficiently in packets. MPSSE is capable of a maximum sustained data rate of
30 Mbits/s.
When a channel is configured in MPSSE mode, the IO timing and signals used are shown in Figure 4.7
and Table 4.3 These show timings for CLKOUT=30MHz. CLKOUT can be divided internally to be provide a
slower clock.
Figure 4.7 MPSSE Signal Waveforms
Table 4.3 MPSSE Signal Timings
MPSSE mode is enabled using Set Bit Bang Mode driver command. A hex value of 2 will enable it, and a
hex value of 0 will reset the device. See application note AN2232L-02, “Bit Mode Functions for the
FT2232D” for more details and examples.
The MPSSE command set is fully described in application note AN_108 – “Command Processor For
MPSSE and MCU Host Bus Emulation Modes”.
The following additional application notes are available for configuring the MPSSE :
Name
t1
t2
t3
t4
t5
t6
AN_109 – “Programming Guide for High Speed FTCI2C DLL”
AN_110 – “Programming Guide for High Speed FTCJTAG DLL”
AN_111 – “Programming Guide for High Speed FTCSPI DLL”
Minimum
15
15
11
1
0
Copyright © 2010 Future Technology Devices International Limited
Typical
33.33
16.67
16.67
FT2232H DUAL HIGH SPEED USB TO MULTIPURPOSE UART/FIFO IC
Maximum
7.15
Units
ns
ns
ns
ns
ns
CLKOUT to TDI/DO delay
CLKOUT high period
CLKOUT low period
TDO/DI setup time
TDO/DI hold time
CLKOUT period
Description
Document No.: FT_000061
Clearance No.: FTDI#77
Datasheet Version 2.10
29