FT232HL-REEL FTDI, Future Technology Devices International Ltd, FT232HL-REEL Datasheet - Page 19

• Manufacturer Part Number: FT232HL-REEL
• Description: IC HS USB TO UART/FIFO 48QFN
• Manufacturer: FTDI, Future Technology Devices International Ltd

Specifications of FT232HL-REEL

• Number Of Channels: 1, UART
• Fifo's: *
• Protocol: RS-232, RS-422, RS-485
• Voltage - Supply: 1.62 V ~ 1.98 V, 2.97 V ~ 3.63 V
• With Parallel Port: Yes
• With False Start Bit Detection: Yes
• With Modem Control: Yes
• Mounting Type: *
• Package / Case: *
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• With Auto Flow Control: -
• With Irda Encoder/decoder: -
• With Cmos: -
• Other names: 768-1101-2

3.5.7 FT232H Pins Configured as a CPU-style FIFO Interface
The FT232H can be configured in a CPU-style FIFO interface mode which allows a CPU to interface to USB
via the FT232H. This mode is enabled in the external EEPROM.
When configured in this mode, the pins used and the descriptions of the signals are shown in Table 3.12
Table 3.12 CPU-style FIFO Interface Configured Pin Descriptions
For a functional description of this mode, please refer to section 4.10
13, 14, 15, 16,
17, 18, 19, 20
Pin No.
21
25
26
27
28
Copyright © 2011 Future Technology Devices International Limited
ADBUS[7:0]
Name
SIWU#
CS#
RD#
WR
A0
FT232H SINGLE CHANNEL HI-SPEED USB TO MULTIPURPOSE UART/FIFO IC
INPUT
INPUT
INPUT
INPUT
INPUT
Type
I/O
D7 to D0 bidirectional data bus
Active low chip select input
Address bit A0
Active Low FIFO Read input
Active Low FIFO Write input
Tie this pin to VCCIO if not used – otherwise, for
normal operation
The Send Immediate / WakeUp signal combines two
functions on a single pin. If USB is in suspend mode
(PWREN# = 1) and remote wakeup is enabled in the
EEPROM, strobing this pin low will cause the device to
request a resume on the USB Bus. Normally, this can
be used to wake up the Host PC.
During normal operation (PWREN# = 0), if this pin is
strobed low any data in the device RX buffer will be
sent out over USB on the next Bulk-IN request from
the drivers regardless of the pending packet size. This
can be used to optimize USB transfer speed for some
applications.
Fast Serial Interface Configuration
Description
Document No.: FT_000288
Clearance No.: FTDI #199
Datasheet Version 1.2
19