31-224 AMPHENOL RF, 31-224 Datasheet - Page 2

• Manufacturer Part Number: 31-224
• Description: BNC TO TWIN AX PLUG
• Manufacturer: AMPHENOL RF
• Series: BNC, Twinr
• Type: Cable Plugr

Specifications of 31-224

• Connector Style: BNC, Twin
• Connector Type: Plug, Male Pins; Receptacle, Female Sockets
• Contact Termination: Clamp and Solder
• Impedance: 50 Ohm
• Mounting Type: Panel Mount, Bulkhead - Front Side Nut
• Fastening Type: Bayonet Lock
• Cable Group: RG-108A
• Frequency - Max: 4GHz
• Frequency-max: 4GHz
• Body Style: Straight Plug
• Coaxial Termination: Solder / Clamp
• Rg Cable Type: RG-108A
• Contact Material: Brass
• Contact Plating: Silver
• Angle: Straight
• Application: Commercial
• Cable Type: RG/U 108A
• Finish, Housing: Nickel
• Material, Dielectric: TFE/Noryl
• Material, Housing: Brass
• Mating Type: Bayonet
• Primary Type: BNC
• Temperature Range: -65 to +165 (TFE), -45 to +121 (Noryl) °C
• Termination: Solder
• Voltage, Rating: 100 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Features: -
• Color: -
• Lead Free Status / Rohs Status: RoHS Compliant part
• Other names: 031-224; ARF1037

Assembly Instructions-C33
Twin BNC
CLAMP PLUGS
Amphenol Corporation Tel: [phone]
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
clamp
nut
washer
gasket
clamp
clamp
braid
bushing
insulator
rear
.375(9.5)
.172(4.4)
308
female/male
Step 1 Cut end of cable sharp and square. Slide clamp nut, washer
Step 2 Pull braid forward and taper toward conductors. Slide braid
Step 3 Fold back braid, trim to proper length so no braid strands
Step 4 Bend connectors out as necessary for alignment and slide
Step 5 Slide front insulator over contacts and butt against contact
Step 6 Insert prepared cable termination into connector body.
contacts
and clamp gasket over jacket. Strip jacket to dimension
shown. Comb out braid and fold out. Bare conductors to
dimension shown.
clamp over braid as shown and push against cable jacket.
extend beyond shoulder of braid clamp and evenly form
over braid clamp as shown. Slide on bushing. Tin center
conductors using minimum amount of heat.
on rear insulator. Solder contacts. Remove any excess
solder from contact O.D.
shoulders as shown.
Make sure sharp edge of braid clamp seats properly in
V-groove clamp gasket. Tighten securely, turning nut only.
Do not twist connector body.
insulator
front
Amphenol
plug body
31-2226
31-224
www.amphenolrf.com
®