RDC503013A ALPS, RDC503013A Datasheet - Page 6

• Manufacturer Part Number: RDC503013A
• Description: Industrial Motion & Position Sensors 10K ohm 3.5mm dia +-2% linearity
• Manufacturer: ALPS

Specifications of RDC503013A

• Voltage Rating: 5 VDC
• Tolerance: 30 %
• Temperature Range: - 40 C to + 120 C
• Maximum Operating Temperature: + 150 C
• Maximum Voltage: 16 VDC
• Mounting Style: SMD/SMT
• Total Resistance: 10000 Ohms
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Magnetic
Sensor
Resistive
Sensor
26
Resistive Sensors
〔Total Resistance〕
〔Rating Voltage〕
1. Recommended reflow conditions
2. Cleaning Cleaning should not be attempted.
3. Type of solder to be used Use cream solder that contains 10 - 15 %wt flux.
4. Number of solder applications - apply solder only once
Notes
1. When using an infrared reflow oven, solder may not always be applied as intended. Be sure to use a hot air reflow
2. The temperatures given above are the maximum temperatures at the terminals of the potentiometer when
3. Conditions vary to some extent depending on the type of reflow bath used. Be sure to give due consideration to this
Analog Output Contact Type Sensor
The total resistance, with the shaft（lever）placed at the end of terminal 1 or 3, shall be determined by measuring the
resistance between the resistor terminals 1 and 3 unless otherwise specified.
The rating voltage corresponding to the rated power shall be determined by the following equation. When the resulting
rated voltage exceeds the maximum operating voltage of a specific resistor, the maximum operating voltage shall be
taken as the rated voltage.
Soldering Conditions
Measurement and Test Methods
oven or a type that uses infrared rays in combination with hot air.
employing a hot air reflow method. The temperature of the PC board and the surface temperature of the
potentiometer may vary greatly depending on the PC board material, its size and thickness. Ensure that the surface
temperature of the potentiometer does not rise to 240˚C or greater.
prior to use.
Soldering Conditions
Temperature
Maximum temperature : 250˚C max.
Preheat temperature : 150˚C.
Room temperature
200˚C
R：Total nominal resistance （ Ω）
E：Rated voltage （V）
P：Rated power （ W）
E=√
−
P ・ R
2 min.max.
4 min.max.
40s max.
10s max.