CA052X472K5RACTU Kemet, CA052X472K5RACTU Datasheet - Page 5

• Manufacturer Part Number: CA052X472K5RACTU
• Description: Capacitor Arrays & Networks 50volts 4700pF 10% 0508 X7R
• Manufacturer: Kemet

Specifications of CA052X472K5RACTU

• Voltage Rating: 10 Volts
• Number Of Elements: 2
• Operating Temperature Range: - 55 C to + 125 C
• Termination Style: SMD/SMT
• Dimensions: 1.3 mm L x 2.1 mm W x 0.8 mm H
• Product: Ceramic Capacitor Arrays
• Capacitance: 0.22 uF
• Tolerance: 10 %
• Package / Case: 0508 (1220 metric)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

SMD MLCCs – Capacitor Array, C0G Dielectric, 10VDC-200VDC, (Commercial & Automotive Grade)
Table 4 – Performance & Reliability: Test Methods and Conditions
© KEMET Electronics Corporation • P.O. Box 5928 • Greenville, SC 29606 [phone] • www.kemet.com
Resistance to Solvents
High Temperature Life
Temperature Cycling
Moisture Resistance
Mechanical Shock
Terminal Strength
Biased Humidity
Thermal Shock
Solderability
Storage Life
Board Flex
Stress
MIL-STD-202 Method 108/
MIL-STD-202 Method 106
MIL-STD-202 Method 108
MIL-STD-202 Method 103
MIL-STD-202 Method 107
MIL-STD-202 Method 213
MIL-STD-202 Method 215
JESD22 Method JA-104
Reference
JIS-C-6429
JIS-C-6429
J-STD-002
EIA-198
Appendix 1, Note: Force of 1.8kg for 60 seconds.
Appendix 2, Note: 2mm (min) for all except 3mm for C0G.
Magnification 50X. Conditions:
1000 Cycles (-55°C to +125°C), Measurement at 24 hrs. +/- 2 hrs after test conclusion.
Load Humidity: 1000 hours 85°C/85%RH and Rated Voltage.Add 100K ohm resistor. Measurement
at 24 hrs. +/- 2 hrs after test conclusion.
Low Volt Humidity: 1000 hours 85C°/85%RH and 1.5V.Add 100K ohm resistor.
Measurement at 24 hrs. +/- 2 hrs after test conclusion.
t = 24 hours/cycle. Steps 7a & 7b not required. Unpowered.
Measurement at 24 hrs. +/- 2 hrs after test conclusion.
-55°C/+125°C. Note: Number of cycles required-300, Maximum transfer time-20 seconds, Dwell
time-15 minutes. Air-Air.
1000 hours at 125°C (85°C for X5R, Z5U and Y5V) with 2X rated voltage applied.
150°C, 0VDC, for 1000 Hours.
Figure 1 of Method 213, Condition F.
Add aqueous wash chemical - OKEM Clean or equivalent.
a) Method B, 4 hrs @ 155°C, dry heat @ 235°C
b) Method B @ 215°C category 3
c) Method D, category 3 @ 260°C
Test or Inspection Method
C1016-1• 12/9/2010
5 5