EET-UQ2W561DA Panasonic, EET-UQ2W561DA Datasheet - Page 5

• Manufacturer Part Number: EET-UQ2W561DA
• Description: Aluminum Electrolytic Capacitors - Snap In 560uF 450V ELECT TS-UQ
• Manufacturer: Panasonic
• Series: TS-UQr

Specifications of EET-UQ2W561DA

• Esr: 0.355 Ohms
• Operating Temperature Range: - 25 C to + 85 C
• Diameter: 30 mm
• Length: 50 mm
• Product: General Purpose Electrolytic Capacitors
• Dissipation Factor Df: 15
• Load Life: 2000 Hrs
• Number Of Pins: 2
• Termination Style: Snap In
• Test Frequency: 120 Hz
• Capacitance: 560 uF
• Tolerance: 20 %
• Voltage Rating: 450 Volts
• Ripple Current: 2.82 Amps
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

1 General Specifications
Design and specifi cations are subject to change without notice. Ask factory for technical specifi cations before purchase and/or use.
Capacitance
Nominal capacitance is specified at a frequency
of 120Hz and a temperature of 20°C. Unless
specified
tolerance is ±20% of the nominal value.
Working Voltage
The maximum allowable sum of continuous DC
voltage plus peak ripple voltage which can be
applied to the capacitor.
Surge Voltage
The maximum transient voltage level allowed for
short
permanent damage to the capacitor. Values are
listed in the standard product ratings.
Leakage Current
Imperfections in the capacitor dielectric allow a
small current to flow. This resultant leakage
current is specified as a maximum after 5
minutes application of rated voltage at 20°C.
See individual series listings for leakage current
equations.
ESR (Equivalent Series Resistance)
Equivalent
generation within the capacitor when AC ripple
current flows through the capacitor. Maximum
ESR is normally specified at 120Hz, 20°C.
Ripple Current
Ripple current is the rms value of alternating
current flowing through a capacitor. This current
causes an internal temperature rise due to
power losses within the capacitor.
The standard product tables list allowable ripple
current limits at specified maximum operating
temperatures.
Ripple current multipliers for other temperatures
and frequencies are listed in the introductory
page for each series.
Endurance Life Test
Endurance life is the minimum time a capacitor
can operate under worst case conditions.
Whenever a doubt about safety arises from this product, please contact us immediately for technical consultation.
periods
otherwise,
series
of
resistance
time
standard
without
causes
capacitance
sustaining
heat
2 Storage Life
Shelf Life Test
Measurements are to be performed after
applying DC working voltage for 30 minutes.
Same as Endurance Test requirements above.
Leakage current will increase during extended
storage.
Capacitors should be stored in temperatures not
to exceed 40°C and protected from direct
exposure to sunlight.
Under normal conditions, storage life can
exceed 10 years.
It is recommended that the leakage current be
checked for conformance to the specified limit if
the capacitor has been stored for four years or
more.
Post test requirements at +20°C:
Leakage Current:
Applied Voltage: Rated DC voltage
Applied Voltage: None
Ambient Temp.: Maximum specified
Ambient Temp.: Maximum specified
Ripple Current: Maximum specified value
Post test requirements at +20°C:
D. F. / E.S.R.:
Cap. change:
Duration: Specified hours of life
Duration: 1000 hours
operating temperature
applied DC voltage plus
the peak ripple voltage
should not exceed rated
working voltage)
measured value
value
operating temperature
(the sum of the
Initial specified value
±20% of initial
200% of initial specified
5