B41456B9228M EPCOS Inc, B41456B9228M Datasheet - Page 13
![Aluminum Electrolytic Capacitors - Screw Terminal 2200uf 100volts 35.7x55.7mm](/photos/16/28/162849/epcosscrewterml_sml.jpg)
B41456B9228M
Manufacturer Part Number
B41456B9228M
Description
Aluminum Electrolytic Capacitors - Screw Terminal 2200uf 100volts 35.7x55.7mm
Manufacturer
EPCOS Inc
Series
B41456r
Datasheet
1.B41456B7109M.pdf
(17 pages)
Specifications of B41456B9228M
Esr
80 mOhms
Operating Temperature Range
- 40 C to + 85 C
Diameter
35 mm (1.375 in)
Length
35 mm (1.375 in)
Product
Aluminum Electrolytic Capacitors
Termination Style
Screw
Capacitance
2200 uF
Tolerance
20 %
Voltage Rating
100 Volts
Lead Spacing
12.7 mm (0.5 in)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
B41456B9228M000
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
Company:
Part Number:
B41456B9228M000
Manufacturer:
EPCOS
Quantity:
30 000
Company:
Part Number:
B41456B9228M000
Manufacturer:
Coilcraft
Quantity:
130 000
Product safety
The table below summarize the safety instructions that must be observed without fail. A detailed
description can be found in the relevant sections of chapter "General technical information".
Topic
Polarity
Reverse voltage
Upper category
temperature
Maintenance
Mounting
position of screw
terminal capacitors
Mounting of
single-ended
capacitors
Robustness of
terminals
Soldering
Please read Cautions and warnings and
Important notes at the end of this document.
Safety information
Make sure that polar capacitors are connected
with the right polarity.
Voltages polarity classes should be prevented by
connecting a diode.
Do not exceed the upper category temperatur.
Make periodic inspections of the capacitors.
Before the inspection, make sure that the power
supply is turned off and carefully discharge the
electricity of the capacitors.
Do not apply any mechanical stress to the
capacitor terminals.
Do not mount the capacitor with the terminals
(safety vent) upside down.
The internal structure of single-ended capacitors
might be damaged if excessive force is applied to
the lead wires.
Avoid any compressive, tensile or flexural stress.
Do not move the capacitor after soldering to PC
board.
Do not pick up the PC board by the soldered
capacitor.
Do not insert the capacitor on the PC board with a
hole space different to the lead space specified.
The following maximum tightening torques must
not be exceeded when connecting screw
terminals:
M5: 2 Nm
M6: 2.5 Nm
Do not exceed the specified time or temperature
limits during soldering.
Page 13 of 17
Compact
B41456, B41458
Reference
Chapter "General
technical information"
1
"Basic construction of
aluminum electrolytic
capacitors"
3.1.6
"Reverse voltage"
7.2
"Maximum permissible
operating temperature"
10
"Maintenance"
11.1.
"Mounting positions of
capacitors with screw
terminals"
11.4
"Mounting
considerations for
single-ended capacitors"
11.3
"Mounting torques"
11.5
"Soldering"
85 C