MDEV-433-HH-KF1-MS Linx Technologies Inc, MDEV-433-HH-KF1-MS Datasheet - Page 2

RF Modules & Development Tools 1 Button MS Keyfob Dev Sys 433MHz

MDEV-433-HH-KF1-MS

Manufacturer Part Number
MDEV-433-HH-KF1-MS
Description
RF Modules & Development Tools 1 Button MS Keyfob Dev Sys 433MHz
Manufacturer
Linx Technologies Inc
Datasheet

Specifications of MDEV-433-HH-KF1-MS

Product
RF Development Tools
Maximum Frequency
433.92 MHz
Supply Voltage (max)
9 V
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
MS SERIES DECODER DEVELOPMENT BOARD
Figure 1: The MS Series Decoder Development Board
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Page 2
3
2
1
9V Battery
Power Jack
On-Off Switch
Voltage Regulator
QS Series USB Module
Prototype Area
Break-out Header
RP-SMA Antenna Connector
LR Series Receiver
MS Series Decoder
Data Line LEDs
Indicator LEDs
Function Switches
LEARN Button
4
6
5
7
13
11
10
12
14
9
8
USING THE MASTER DEVELOPMENT SYSTEM
TROUBLESHOOTING
1. Press and hold the CREATE_ADDR button on the transmitter to create a new
2. Once the button is released, the MODE_IND LED will begin to flash to indicate
3. Press the LEARN button on the decoder board and the MODE_IND LED will
• Check the battery to make sure it is not dead.
• Make sure the baud rate switches are set to 9,600bps on the decoder board.
• Make sure that the antenna is connected.
• Check to see if the PDN switch is on, placing the decoder into Power Down
• Make sure that you set your Control Permissions correctly. If you have not set
Using the Master Development System is straightforward. After unpacking the
board, screw the antenna onto the connector, install the supplied 9V battery, and
turn on the power switch. The encoder and decoder will have default settings
from the factory and will work straight out of the box. To create a new address,
follow these easy steps:
If the boards fail to work out of the box, then try the following:
If all of these appear to be in order, then you can call 800-736-6677 or e-mail
techsupport@linxtechnologies.com for technical support.
Code Word. This is done by sticking a paper clip through the hole on the back
of the case and pressing the button inside. The Code Word will be randomized
for as long as the button is held down. Once comfortable that the number is
sufficiently random, release the button.
that it is ready to accept Control Permissions. Press all of the data line buttons
that are to be recognized, then press the CREATE_ADDR button again or let it
time out after seventeen seconds.
start flashing. Press any of the data line buttons on the transmitter and press the
LEARN button again. The encoder’s Code Word has now been learned by the
decoder and they will operate together.
Mode. In most cases, the encoder PDN switch should be on.
the encoder to use a particular line, then when you press a button on the
encoder board, the MODE_IND LED on the decoder board will light up, but the
data line LED will not light up.
Page 3

Related parts for MDEV-433-HH-KF1-MS