RK-WI.232FHSS-25-FCC-R Radiotronix, RK-WI.232FHSS-25-FCC-R Datasheet - Page 8

• Manufacturer Part Number: RK-WI.232FHSS-25-FCC-R
• Description: RF Modules & Development Tools Rapid Development Kit FCC certified
• Manufacturer: Radiotronix

Specifications of RK-WI.232FHSS-25-FCC-R

• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: RK-WI232FHSS-25-FCC-R

RK-Wi.232FHSS-25/250 Rapid Development Kit
3.5 Diagnostic Window
The diagnostic window provides a means to switch the transmitter and receiver on and off, enable and
disable carrier modulation, start, stop and set hop sequence, set transmitter power, set transceiver
channels and perform bit error testing.
4 Using the Evaluation Software.
4.1 Setting Register Values.
On both the Volatile and Non-Volatile pages, the registers are labeled by function. To set a register value,
select the value from the options available for that register and click the “Write” button. To perform a read
of that register, simply click the “Read” button. Descriptions of the register functions can be found in the
Wi.232FHSS Users Manual.
4.2 Power Mode.
This selects the mode of both the transmitter and receiver. The mode is not set until “Set Tx 1-Channel
Diag”, “Tx FHSS Diag” or “Set RX Diag” is pressed.
4.3
Receive Diagnostic consists of four radio buttons which select the transmit channel. Low, Mid and High
are quick reference buttons which can be used to select the lowest, the middle, or the highest channel.
Any specific channel can be selected by using the controls above the “Set RX Diag” button.
The “Set RX Diag” button switches on the receiver using the channel set by the channel selector.
If a “…1010101010101…” bit pattern is being received at the frequency and baud rate set up in the
relevant registers, a BER test will be performed and the number and percent of bit errors is displayed in
the panel otherwise populated with the text “Unknown”.
4.4
Transmit Diagnostic consists of four radio buttons which select the transmit channel. Low, Mid and High
are quick reference buttons which can be used to select the lowest, the middle, or the highest channel.
Any specific channel can be selected by using the controls below the “Set 1-Channel Tx Diag” button.
The “Set 1-Channel Tx Diag” button switches on the transmitter using the channel and mode set up using
the channel selector and transceiver mode controls.
A “…1010101010101…” bit pattern is transmitted for bit error testing with another system. This is not a
true pseudo-random sequence BER test.
© 2002-2005 Radiotronix Inc, all rights reserved
Receive Diagnostic.
Transmit Diagnostic.
- 7 -
User’s Manual (Preliminary)
12/11/2006