Wi.232DTS-FCC-ST-R Radiotronix, Wi.232DTS-FCC-ST-R Datasheet - Page 12
![RF Modules & Development Tools FCC APPROVED MODULE W/ STRAIGHT RPSMA](/photos/15/97/159757/landingpageradiotronixwifreestar232dtsstandup_sml.jpg)
Wi.232DTS-FCC-ST-R
Manufacturer Part Number
Wi.232DTS-FCC-ST-R
Description
RF Modules & Development Tools FCC APPROVED MODULE W/ STRAIGHT RPSMA
Manufacturer
Radiotronix
Datasheet
1.WI.232DTS-FCC-ST-R.pdf
(23 pages)
Specifications of Wi.232DTS-FCC-ST-R
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
WI232DTS-FCC-ST-R
WI.232DTS-FCC-R USER’S MANUAL
4.4. Transmit Diagnostic
4.5. Transmit Diagnostic
Transmit Diagnostic consists of four radio buttons which select the transmit channel. Low, Mid and High
are quick reference buttons which can be used to select the lowest, the middle, or the highest channel.
Any specific channel can be selected by using the controls below the “Set TX Diag” button.
The “Set TX Diag” button switches the transmitter on using the channel and mode selected in the
channel selector and transceiver mode controls. A “…1010101010101…” bit pattern is transmitted for bit
error testing with another system or RF carrier analysis.
Receive Diagnostic consists of four radio buttons which select the transmit channel. Low, Mid and High
are quick reference buttons which can be used to select the lowest, the middle, or the highest channel.
Any specific channel can be selected by using the controls above the “Set RX Diag” button.
The “Set RX Diag” button switches on the receiver using the channel and mode selected in the channel
selector and transceiver mode controls. Additionally, the module enters the diagnostic bit error test.
If a “…1010101010101…” bit pattern is received at the frequency and baud rate set up in the relevant
registers, the BER test will return the number and percent of bit errors. This information is displayed in
the panel below the “Set RX Diag” button. If no transmission is present, or the transmission is at the
wrong frequency or data rate, the module may enter an infinite loop waiting for the beginning of the data.
In this case, the module should be powered down and back up to return the module to its normal
operating mode.
11