MDM-21PH003F ITT Cannon, MDM-21PH003F Datasheet - Page 69

• Manufacturer Part Number: MDM-21PH003F
• Description: MICRO 21POS PIN 18"
• Manufacturer: ITT Cannon

Specifications of MDM-21PH003F

• Connector Type: Micro D
• Gender: Plug
• No. Of Contacts: 21
• Contact Termination: Crimp / Solder
• Connector Mounting: Cable
• Contact Plating: Gold
• Contact Material: Copper Alloy
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: IMDM-21PH003F

CTA Assembly Instructions
INSERTION
EXTRACTION
www.ittcannon.com
The Centi Line - .075" Contact Spacing
Dimensions shown in inch (mm)
Specifications and dimensions subject to change
1. Place the connector into the slot in the assembly block
with the arrows on the insulator pointing downward. The
connector will bottom against the internal shoulder in the
groove in the assembly block. Start contact insertion by
placing the crimped contact in the cavity by hard.
3. With firm steady pressure, push the contact into the
cavity until the resilient internal shoulder snaps into the
locking groove in the contact. To prevent over insertion,
the tool tip bottoms against the rear of the insulator.
1. To extract the contacts, place the conector face up in
the assembly block so that the contact to be extracted is
in the end of the block that has a fully slotted opening.
3. Insert the extraction tool into the cavity and apply firm
pressure until the contact is pushed thru the rear of the
connector.
69
4. The guide post and polarizing posts are inserted in teh
same manner as the contacts. The guide posts are inserted
into the socket insulator, and the polarizing posts are
inserted into the pin insulartor. The corresponding contact
in the mating insulator must be removed for each.
2. Position the insertion tool tip on the rear of contact as
shown. The insulation must be pulled back from the crimp
pot approximately 1/32" to allow the tool tip to butt
against the contact crimp pot.
2. The pin extraction tool tip is tubular, slides over the pin
bundle and butts against the front shoulder of the pin. The
socket extraction tool is a solid rod that fits into the socket
contact, the external shoulder butts against the contact
socket shoulder.
4. Lift the insulator from the groove and pull the contact
out. Repeat for balance of contacts to be removed.
.275 (6.98)
MAX.
Guide Posts
Polarizing Posts
2D/CTA
.475 (12.06)
MAX.