62-2324-2001-8 3M, 62-2324-2001-8 Datasheet - Page 3

• Manufacturer Part Number: 62-2324-2001-8
• Description: TAPE SCOTCH-WELD 4IN X 36YD
• Manufacturer: 3M
• Series: Scotch-Weld™r

Specifications of 62-2324-2001-8

• Tape Type: Film
• Adhesive: Epoxy Thermosetting
• Backing, Carrier: Crepe Paper
• Thickness: 0.0179" (17.9 mils, 0.455mm)
• Thickness - Adhesive: 0.0100" (10.0 mils, 0.254mm)
• Thickness - Backing, Carrier, Liner: 0.0079" (7.9 mils, 0.201mm)
• Width: 4.00" (101.60mm) 1/3'
• Length: 108' (32.9m) 36 yds
• Color: White, Off
• Usage: Bonding
• Temperature Range: 250°F (121°C) - 60 minutes
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: Q5481988

5.2 EXTINGUISHING MEDIA
Use fire extinguishers with class B extinguishing agents (e.g., dry chemical, carbon dioxide).
5.3 PROTECTION OF FIRE FIGHTERS
Special Fire Fighting Procedures:
(SCBA).
Unusual Fire and Explosion Hazards:
Accidental Release Measures: Observe precautions from other sections. Call 3M- HELPS line (1-800-364-3577) for more
information on handling and managing the spill. Ventilate the area with fresh air. Contain spill. Collect as much of the spilled
material as possible. Place in a closed container approved for transportation by appropriate authorities.
7.1 HANDLING
Do not eat, drink or smoke when using this product. Wash exposed areas thoroughly with soap and water. Keep away from heat,
sparks, open flame, pilot lights and other sources of ignition. Avoid breathing of vapors created during cure cycle. Avoid breathing of
dust created by cutting, sanding, grinding or machining. Avoid eye contact with dust or airborne particles.
7.2 STORAGE
Store away from heat. Store out of direct sunlight.
8.1 ENGINEERING CONTROLS
Provide ventilated enclosure for heat curing. Provide appropriate local exhaust for cutting, grinding, sanding or machining. Curing
enclosures must be exhausted to outdoors or to a suitable emission control device. Use general dilution ventilation and/or local
exhaust ventilation to control airborne exposures to below Occupational Exposure Limits and/or control dust, fume, or airborne
particles. If ventilation is not adequate, use respiratory protection equipment.
8.2 PERSONAL PROTECTIVE EQUIPMENT (PPE)
8.2.1 Eye/Face Protection
Avoid eye contact.
The following eye protection(s) are recommended: Safety Glasses with side shields.
8.2.2 Skin Protection
Avoid skin contact.
_________________________________________________________________________________________________
MATERIAL SAFETY DATA SHEET 3M(TM) Scotch-Weld(TM) AF 111 (.08 Wt.) Structural Film
SECTION 6: ACCIDENTAL RELEASE MEASURES
SECTION 7: HANDLING AND STORAGE
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
In the event of a release of this material, the user should determine if the release qualifies as reportable according to
local, state, and federal regulations.
Note: See STABILITY AND REACTIVITY (SECTION 10) for hazardous combustion and thermal decomposition
information.
Wear full protective equipment (Bunker Gear) and a self-contained breathing apparatus
No unusual fire or explosion hazards are anticipated.
07/17/2008
Page 3 of 7