22-2X36YD 3M, 22-2X36YD Datasheet - Page 2

• Manufacturer Part Number: 22-2X36YD
• Description: TAPE ELECTRICAL HEAVY DUTY 2"
• Manufacturer: 3M
• Series: Scotch® 22r

Specifications of 22-2X36YD

• Tape Type: Electrical
• Adhesive: Rubber
• Backing, Carrier: PVC (Poly Vinyl Chloride)
• Thickness: 0.0100" (10.0 mils, 0.254mm)
• Width: 2.00" (50.80mm)
• Length: 108' (32.9m) 36 yds
• Color: Black
• Usage: Electrically Insulating
• Temperature Range: 176°F (80°C)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Thickness - Adhesive: -
• Thickness - Backing, Carrier, Liner: -
• Other names: 00054007100676; 05400710067; 80012017077

Voltage Rating
UL 510
Dielectric Breakdown
ASTM D-1000
Standard Condition
High Humidity
Insulation Resistance
ASTM D-1000
Note: These are typical values and should not be
used for specification purposes.
Specification
Product
The tape is based on polyvinyl chloride (PVC) and/or
its copolymers and has a rubber based, pressure
sensitive adhesive. The tape shall be 10 mils thick,
and be UL Listed and marked per UL Standard 510
as “Flame Retardant and Weather Resistant”. The
tape must be applicable at temperatures ranging from
15°F through 100°F (-10°C through 38°C) without
loss of physical properties. The tape shall be
classified for use in both indoor and outdoor
environments. The tape shall be compatible with
synthetic cable insulation, jackets and splicing
compounds. The tape will remain stable and will not
telescope more than 0.1 inches when maintained at
temperatures below 120°F (50°C).
Engineering/Architectural Specification
Primary electrical insulation (branch wiring in
wet or dry locations):
All splices for 600 volt wire rated 80°C (176°F) and
below shall be insulated with a minimum of two half
lapped layers of Scotch
ÒScotchÓ and ÒScotchfilÓ are trademarks of 3M.
Important Notice
Before using this product, you must evaluate it and determine if it is suitable for your intended application. You assume all risks and
liability associated with such use.
Warranty; Limited Remedy; Limited Liability. This product will be free from defects in material and manufacture as of the date of
purchase. 3M MAKES NO OTHER WARRANTIES INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY OF
MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. If this product is defective within the warranty period stated
above, your exclusive remedy shall be, at 3MÕs option, to replace or repair the 3M product or refund the purchase price of the 3M
product. Except where prohibited by law, 3M will not be liable for any loss or damage arising from this 3M product, whether
direct, indirect, special, incidental or consequential regardless of the legal theory asserted.
Electrical Products Division
6801 River Place Blvd.
Austin, TX 78726-9000
www.3M.com/elpd
®
22 Vinyl Electrical Tape.
>1 x 10
90% of Standard
6
megohms
12,000V
600V
padded with Scotchfilä Electrical Insulation Putty or
Scotch
insulating with 22 tape.
Mechanical protection (outer jacketing)
All rubber and thermoplastic insulating high voltage
power cable tape splices and repairs shall be
overwrapped with at least two half lapped layers of
Scotch
Insulation Techniques
The tape shall be applied in half lapped layers with
sufficient tension to produce a uniform wind (for
most applications, this tension will reduce the tape’s
width to approximately 5/8 of its original width). On
pigtail splices, the tape shall be wrapped beyond the
end of the wires and then folded back, leaving a
protective cushion to resist cut through. Wrap tape
up-hill, taping from a smaller diameter surface to a
larger diameter surface. Apply the tape with no
tension on the last wrap to prevent flagging.
Shelf Life
Scotch 22 Vinyl Electrical Tape has a 5-year shelf
life (from date of manufacture) when stored under the
following recommended storage conditions. Store
behind present stock in a clean, dry place at a
temperature of 70°F (21˚C) and 40-50% relative
humidity. Good stock rotation is recommended.
Availability
Scotch 22 Vinyl Electrical Tape is available from
your local 3M authorized distributor in the following
standard roll size:
Other lengths and widths are available by special
request.
®
®
130C Rubber Splicing Tape prior to
22 vinyl electrical tape.
3/4 in. x 36 yd.
© 3M IPC 2000 78-8124-4842-7-B