A165L-JGA-5D-2 Omron, A165L-JGA-5D-2 Datasheet - Page 26
![no-image](/images/manufacturer_photos/0/4/494/omron_sml.jpg)
A165L-JGA-5D-2
Manufacturer Part Number
A165L-JGA-5D-2
Description
SWITCH PB ILLUM RCT ALT DPDT GRN
Manufacturer
Omron
Series
A16r
Type
Illuminatedr
Datasheet
1.A16-5DSG.pdf
(28 pages)
Specifications of A165L-JGA-5D-2
Circuit
DPDT
Switch Function
On-On
Contact Rating @ Voltage
5A @ 125VAC
Actuator Type
Rectangular Button
Illumination Type, Color
LED, Green
Illumination Voltage (nominal)
5 VDC
Mounting Type
Panel Mount
Termination Style
Solder, Quick Connect - .110" (2.8mm)
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
A165LJGA5D2
Panel Mounting
After mounting the Pushbutton Unit (i.e., the Pushbutton and the
Case) to the panel, snap in the Switch Unit (i.e., the Switch and the
Lamp) from the back of the panel.
Mounting to the Panel
Mounting the Switch Unit
• Insert the Pushbutton Unit into the front of the panel, and fix the lock
• Make sure that the lock ring is aligned with the thread of the Case
• Tighten the mounting nuts to a torque of 0.29 to 0.49 N·m.
• Snap on the Switch Unit to the Pushbutton Unit.
• Make sure that the Switch Unit has the correct orientation when
ring and mounting nut from the terminal side.
and the edge of the lock ring is touching the panel.
snapping it onto the Case. Align the dimple on the Case with the
groove between the case guards on the NC terminal side of the
Switch Unit in the way shown below, and push the Switch Unit into
the Case until it clicks into place. Confirm that the Switch Unit is
securely in place before using.
Case
dimple
Thread
Edge
Panel
Lock ring
Groove between case guards
Mounting nut
NC terminal
Removing the Switch Unit
Note: Refer to page 21 for PCB terminals.
Engraving
Engraving the Legend Plate
Mounting and Replacing the Pushbutton
Removing and Mounting the Pushbutton
(1) Remove the Pushbutton as shown in the following diagram. If the
(2) When mounting the Operation Unit to the Case, press the entire
• Grip the part between the Switch holder of the Case and the Switch
• The characters must not be engraved deeper than 0.4 mm.
• Apply an alcohol-based paint coating, such as melamine,
Unit using the A16Z-5080 Extractor, and pull to remove the Switch
Unit.
phthalate, or acrylic resin paint coating.
Pushbutton cannot be removed by hand, use the A3PJ-5080
Extractor.
surface of the Operation Unit to surface A of the Case as shown
in the following diagram.
A16Z-5080 Extractor
Case
Operation Unit
Surface A
Pushbutton
A16
26