ZB2430-Q-E-S-A Laird Technologies, ZB2430-Q-E-S-A Datasheet - Page 41

• Manufacturer Part Number: ZB2430-Q-E-S-A
• Description: MOD ANT CHIP ZIGBEE 2-100MW SMT
• Manufacturer: Laird Technologies
• Series: AeroCommr

Specifications of ZB2430-Q-E-S-A

• Frequency: 2.4GHz
• Data Rate - Maximum: 250kbps
• Modulation Or Protocol: 802.15.4 Zigbee
• Applications: AMR, ISM, Security and Access
• Power - Output: 10dBm ~ 20dBm
• Sensitivity: -99dBm
• Voltage - Supply: 3 V ~ 3.5 V
• Current - Receiving: 27mA
• Current - Transmitting: 25mA
• Data Interface: PCB, Surface Mount
• Antenna Connector: On-Board, Chip
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -

3 6
C O N F I G U R I N G T H E Z B 2 4 3 0
Upon receiving this command, a transceiver will respond with the
desired data from the addresses requested by the OEM Host.
*Note: Maximum Length is 0xFC.
EE PROM Byte W ri t e
Upon receiving this command, a transceiver will write the data bytes
to the specified address but will not respond to the OEM Host until
the EEPROM write cycle is complete.
Note: The maximum length of data that can be written in a single
write process is 0x50. If writing the entire 256-byte EEPROM, it is
convenient to perform 64 byte (0x40) writes.
R es et
The OEM Host issues this command to perform a soft reset of the
transceiver. Any transceiver settings modified by CC commands will
revert to the values stored in the EEPROM.
R es t o r e F a ct o r y D ef a u l ts
The OEM Host issues this command to restore the EEPROM
Configuration to factory default.
*Note. This command does not perform a NV Reset.
S o f t Re s et w i t h N V r e s et
The OEM Host issues this command to perform a soft reset of the
transceiver and to erase the network settings stored in the radio’s
non-volatile memory.
commands will revert to the values stored in the EEPROM.
Any transceiver settings modified by CC
Command: <0xCC> <0xC0> <Start> <Length>
Number of Bytes Returned: 4+
Response: <0xCC> <Start> <Length> <Data>
Parameter Range:
<Start>
<Length>
<Data>
Command: <0xCC> <0xC1> <Start> <Length> <Data>
Number of Bytes Returned: 3
Response: <Start> <Length> <Last byte>
Parameter Range:
<Start>
<Length>
<Data>
<Last byte> = Value of last byte written
Command: <0xCC> <0xFF>
Number of Bytes Returned: None
Response: None
Command: <0xCC> <0xFF> <0xDF>
Number of Bytes Returned: None
Response: None
Command: <0xCC> <0xFF> <0xE3>
Number of Bytes Returned: None
Response: None
= EEPROM address to begin reading at
= Length of data to be read
= Requested data
= EEPROM address to begin writing at
= Length of data to be written (Max = 0x50)
= Data to be written