XC09-038PKT-RA Digi International/Maxstream, XC09-038PKT-RA Datasheet - Page 6

• Manufacturer Part Number: XC09-038PKT-RA
• Description: MODEM RF 900MHZ RS232/485 W/ACC
• Manufacturer: Digi International/Maxstream
• Series: 9XCite™r

Specifications of XC09-038PKT-RA

• Frequency: 900MHz
• Data Rate - Maximum: 38.4kbps
• Modulation Or Protocol: FHSS, FSK
• Power - Output: 6dBm
• Sensitivity: -104dBm
• Voltage - Supply: 2.85 V ~ 5.5 V
• Current - Receiving: 45mA
• Current - Transmitting: 55mA
• Data Interface: Connector, Female DB-9
• Antenna Connector: RP-SMA
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Applications: -
• Memory Size: -

Figure 1‐03. DIP Switch Settings
9XCite‐PKG‐R™ RS‐232/485 RF Modem – Product Manual v2.1 [2007.01.04]
Figure 1‐01. Front View
Figure 1‐02. Back View
1‐01a. Power
Switch
Green (middle)
Red (bottom)
1‐01b. LEDs:
Yellow (top)
1‐02a. DIP
1.3. External Interface
Switch
1‐02b. Configuration
1‐01c. DB‐9
Serial Port
Switch
© 2007 MaxStream, Inc.
1‐02c. Antenna
Port
1‐01d. Power
Connector
1-01a. Power Switch
1-01b. I/O & Power LEDs
1-01c. DB-9 Serial Port
1-01d. Power Connector*
1-02a. DIP Switch
1-02b. Config (Configuration) Switch
1-02c. Antenna Port
Move Power Switch to the ON (up) position to power the XCite RS-
232/485 RF Modem.
LEDs indicate modem activity as follows:
Standard female RS-232 (DB-9) DCE connector - Port is also used for
RS-485 and RS-422 connections.
7-18 VDC Power Connector (Center positive, 5.5/2.1 mm) - Power
can also be supplied through Pin 9 of the serial port.
DIP Switch automatically configures the XCite Module to operate in
different modes. Each time the RF modem is powered-on, intelligence
on the XIB-R interface board programs the embedded module accord-
ing to the positions of the DIP Switch. [See the figure below for DIP
Switch settings.]
In cases where AT Commands should not be sent each time the RF
Modem is powered on, the processor must be disabled by populating
J7 on the interface board. [See "Automatic DIP Switch Configura-
tions" section for more information].
Configuration Switch provides an alternate way to enter "AT Com-
mand Mode". To enter "AT Command Mode" at the RF modem's
default baud rate, hold the Configuration Switch down while powering
on the modem using the Power Switch.
This port is a 50 Ohm RF signal connector for connecting to an RPSMA
(Reverse Polarity SMA) type antenna. The RPSMA has threads on the
outside of a barrel and a male center conductor.
Yellow (top LED) = Serial Data Out (to host)
Green (middle) = Serial Data In (from host)
Red (bottom)
powered; it pulses on/off briefly during RF transmission.)
= Power/TX Indicator (Red light is on when