DC-WEM-02T-C Digi International, DC-WEM-02T-C Datasheet - Page 42

• Manufacturer Part Number: DC-WEM-02T-C
• Description: WI-EM 8MB SDRAM 4MB FLASH SINGLE
• Manufacturer: Digi International
• Series: Digi Connect® Wi-EMr

Specifications of DC-WEM-02T-C

• Frequency: 2.4GHz
• Data Rate - Maximum: 11Mbps
• Modulation Or Protocol: 802.11 b
• Applications: General Purpose
• Power - Output: 16dBm
• Sensitivity: -82dBm
• Voltage - Supply: 3.14 V ~ 3.45 V
• Data Interface: Connector, RJ-45
• Memory Size: 4MB Flash, 8MB RAM
• Antenna Connector: 2 X RP-SMA
• Operating Temperature: -30°C ~ 85°C
• Package / Case: Module
• Wireless Frequency: 2.4 GHz
• Interface Type: SMA
• Modulation: CCK, DBPSK, DQPSK
• Security: 64/128 WEP, WPA, 802.11i, TKIP
• Operating Voltage: 3.3 V
• Antenna: SMA
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Current - Transmitting: -
• Current - Receiving: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• For Use With/related Products: NS7520

About Embedded Module LEDs
Hard Reset
4 2
E m b e d d e d M o d u l e R e s e t
Embedded Module Reset
Green
(above yellow LED)
Green
(the one above the red LED)
Yellow
Red
       
LED
For information on LED control, see the NET+Works BSP Porting Guide.
The embedded modules support a hardware reset on pin 10 of the 12-pin header. The unit
will be forced into a hard reset if this pin is pulled low. When used with the development
board, this pin is wired to reset button SW5, which means it acts as a hard reset button.
D i g i C o n n e c t E M & W i - E M H a r d w a r e R e f e r e n c e
This LED is wired to the network hardware and provides an indication of link status.
This LED is software programmable and is wired to processor GPIO register bit
PORTC4 and wired to be lit when low.
This LED is software programmable, wired to processor GPIO register bit PORTC2,
and wired to be lit when low.
This LED is software programmable, wired to processor GPIO register bit PORTC6,
and wired to be lit when low.The default is that this LED indicates power
(and is therefore always on).
Embedded Module LED Description
Description