DG-M10 Digi International, DG-M10 Datasheet - Page 9

• Manufacturer Part Number: DG-M10
• Description: MODULE SATELLITE MODEM DIGI M10
• Manufacturer: Digi International

Specifications of DG-M10

• Frequency: 148MHz ~ 150.05MHz TX, 137MHz ~ 138MHz RX
• Applications: General Purpose
• Power - Output: 5W
• Sensitivity: -120dBm
• Voltage - Supply: 9 V ~ 18 V
• Current - Receiving: 60mA
• Current - Transmitting: 1.5A
• Data Interface: 14 Pin Socket, 1 mm Pitch
• Antenna Connector: MMCX
• Operating Temperature: -40°C ~ 85°C
• Package / Case: Module
• Product: RF Modules
• Maximum Frequency: 150.05 MHz, 138 MHz
• Antenna: MMCX
• Supply Voltage (max): 18 VDC
• Supply Current: 1.5 A, 60 mA
• Maximum Operating Temperature: + 85 C
• Board Size: 7.49 cm x 4.60 cm x 1.32 cm
• Minimum Frequency: 148 MHz, 137 MHz
• Minimum Operating Temperature: - 40 C
• Supply Voltage (min): 9 VDC
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Memory Size: -
• Data Rate - Maximum: -
• Modulation Or Protocol: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant
• Other names: 602-1165

1.2
Once an antenna is properly connected to the Digi m10 and it has a clear line of sight to the sky,
the Digi m10 can start communicating with satellites as they pass by overhead. Availability of
satellites is highly dependent on regional location and how busy a satellite currently is; that is, the
availability of slots.
To transmit a message through the Digi m10 to the satellite, a user must create a message and
communicate it serially to the Digi m10. See the section referring to the types of
Communication methods
various
queued up for transmission and there is a satellite overhead, the Digi m10 will attempt to transmit
the message to the satellite following the cycle shown in the above figure. When the satellite
accepts the message and transmits to the GES, the message then routes to the specified
destination.
Digi International, Inc. © 2009
acknowledgement
Communication using a Digi m10 Satellite
Modem
or the available types of messages that can be sent. At this time,
Figure 1: SCO Report Transmission Cycle
and
priority
levels can be set as well. Once a message has been
Page 9 of 24