RN-24S Roving Networks Inc, RN-24S Datasheet - Page 12
![SUPERMODULE BLUETOOTH CHIP ANT](/photos/14/20/142094/mfg_rn-24_series_sml.jpg)
RN-24S
Manufacturer Part Number
RN-24S
Description
SUPERMODULE BLUETOOTH CHIP ANT
Manufacturer
Roving Networks Inc
Specifications of RN-24S
Frequency
2.4GHz
Data Rate - Maximum
721kbps
Modulation Or Protocol
Bluetooth v2.0+EDR, Class 1 & 2
Applications
Bluetooth v2.0
Power - Output
4dBm
Sensitivity
-80dBm
Voltage - Supply
4 V ~ 24 V
Current - Receiving
40mA
Current - Transmitting
40mA
Data Interface
PCB, Surface Mount
Antenna Connector
On-Board, Chip
Package / Case
Module
Wireless Frequency
2.402 GHz to 2.48 GHz
Interface Type
UART
Data Rate
240 Kbps to 300 Kbps
Modulation
FHSS, GFSK
Operating Voltage
3.3 V
Antenna
Chip Antenna
Board Size
20.32 mm x 50.8 mm x 4.08 mm
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Operating Temperature
-
Memory Size
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
Other names
740-1008
4.1
4.2
www.rovingnetworks.com
GET Commands
D
E
M
O
G<X>
In addition to the above, there are a few other useful commands available.
GB
GK
G&
V
CHANGE Commands
U,<rate>,<E,O,N> -
809 University Avenue
made up of two one byte intervals. The first interval is the OFF period and the
second the ON period. Both are in Hex seconds (not decimal). The maximum value
is 20 seconds for either of the periods. Default is 0000 always actively waiting for a
connection.
Example: S|,0120
20=Decimal 32).
Display basic settings. Address, Name, Uart Settings, Security, Pin code, Bonding,
Remote Address.
Display extended settings: service name, service class, device class, configuration
Timer.
Display remote side modem signal status.
Display other settings. Configuration character, I/O port values, debug mode.
Display stored settings for command X. These commands correspond to the SET
commands above.
Example: GS will return 1 or 0 depending on the value of security.
Returns the Bluetooth Address of the device.
Returns the current connection status: 1=connected, 0 = not connected.
Return a hex byte containing the value of the PIO pins
Return the software release version
Temporary UART Change, will change the serial parameters immediately, but not
store them. Command will return “AOK” at current settings, then automatically exit
command mode, and switch to new baud rate.
Baud rrate must be EXACTLY 4 characters = {1200, 2400, 4800, 9600, 19.2K,
38.4K, 57.6K, 115K, 230K, 460K, 921K }.
Parity is E, O, or N (must be capitals)
This command is effective immediately, does not require reboot.
•
Los Gatos, CA 95032
// cycle ON for one second and OFF for 32 seconds (HEX
~ 12 ~
•
Tel (408) 395-6539
rn-bluetooth-um Version 4.77 1/24/2011
Advanced User Manual
• info@RovingNetworks.com