X09-009NSC Digi International/Maxstream, X09-009NSC Datasheet - Page 11
![no-image](/images/no-image-200.jpg)
X09-009NSC
Manufacturer Part Number
X09-009NSC
Description
MOD RF 900MHZ 9600BPS W/RPSMA
Manufacturer
Digi International/Maxstream
Specifications of X09-009NSC
Frequency
900MHz
Data Rate - Maximum
19.2kbps
Modulation Or Protocol
FSK
Power - Output
100mW
Sensitivity
-110dBm
Voltage - Supply
5V
Current - Receiving
50mA
Current - Transmitting
140mA
Data Interface
PCB, Through Hole
Antenna Connector
RP-SMA
Operating Temperature
0°C ~ 70°C
Package / Case
Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Applications
-
Memory Size
-
Note: RF reception must
complete before the
module is able to enter
into Transmit Mode.
XStream™ OEM RF Module – Product Manual v5.x00 [2006.02.24]
2.2. Modes of Operation
2.2.1. Idle Mode
2.2.2. Transmit Mode
RF transmission begins after either of the following criteria is met:
XStream OEM RF Modules operate in five modes.
Figure 2‐04. XStream Modes of Operation
When not receiving or transmitting data, the module is in Idle Mode. The module uses the same
amount of power in Idle Mode as it does in Receive Mode.
The module shifts into the other modes of operation under the following conditions:
After responding to any of the preceding conditions, the module automatically transitions back
into Idle Mode.
After the first byte of serial data is received in the DI buffer (from the UART), the module
attempts to shift to Transmit Mode and initiate RF connections with other modules. After
transmission is complete, the module returns to Idle Mode.
1.
2.
After either RB or RO conditions are met, the module then initializes a communications channel.
[Channel Initialization is the process of sending an RF initializer that synchronizes receiving
modules with the transmitting module. During channel initialization, incoming serial data
accumulates in the DI buffer.]
Serial data in the DI buffer is grouped into RF packets [refer to PK (RF Packet Size)]; converted
to RF data; then transmitted over-the-air until the DI buffer is empty.
RF data, which includes the payload data, follows the RF initializer. The payload includes up to
the maximum packet size (PK Command) bytes. As the transmitting module nears the end of the
transmission, it inspects the DI buffer to see if more data exists to be transmitted. This could be
the case if more than PK bytes were originally pending in the DI buffer or if more bytes arrived
from the UART after the transmission began. If more data is pending, the transmitting module
assembles a subsequent packet for transmission.
© 2006 MaxStream, Inc. Confidential and Proprietary
• Serial data is received in the DI Buffer (Transmit Mode)
• Valid RF data is received through the antenna (Receive Mode)
• Command Mode Sequence is issued (Command Mode)
• Sleep Mode condition is met (Sleep Mode)
RB bytes have been received in the DI buffer and are pending for RF transmission [refer to
RB (Packetization Threshold) Command, p29].
The RB parameter may be set to any value between 1 and the RF packet size (PK), inclusive.
When RB = 0, the packetization threshold is ignored.
At least one character has been received in the DI buffer (pending for RF transmission) and
RO time has been observed on the UART [refer to RO (Packetization Timeout) Command].
The timeout can be disabled by setting RO to zero. In this case, transmission will begin after
RB bytes have been received in the DI buffer.
The module can only be in one mode at a time.
11