ZMXM-400-1 CEL, ZMXM-400-1 Datasheet - Page 12
![MODULE MATRIX TXRX PCB TRACE ANT](/photos/14/19/141929/zmxm-400-1_sml.jpg)
ZMXM-400-1
Manufacturer Part Number
ZMXM-400-1
Description
MODULE MATRIX TXRX PCB TRACE ANT
Manufacturer
CEL
Series
Matrixr
Datasheet
1.ZMXM-400-KIT-2.pdf
(13 pages)
Specifications of ZMXM-400-1
Frequency
2.4GHz
Data Rate - Maximum
250kbps
Modulation Or Protocol
802.15.4
Applications
Mesh, p2p Networks
Power - Output
10dBm ~ 20dBm
Sensitivity
-92dBm
Voltage - Supply
2.1 V ~ 3.6 V
Current - Receiving
33mA
Current - Transmitting
130mA @ 100mW
Data Interface
PCB, Surface Mount
Memory Size
128kB Flash, 8kB RAM
Antenna Connector
On-Board, Trace
Operating Temperature
-40°C ~ 85°C
Package / Case
Module
Wireless Frequency
2.4 GHz
Interface Type
UART
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
For Use With/related Products
CC2430
PROCESSING (Continued)
Optical Inspection
After soldering the Module to the host board, consider optical inspection to check the following:
•
•
•
Repeating Reflow Soldering
Only a single reflow soldering process is encouraged for host boards.
Wave Soldering
If a wave soldering process is required on the host boards due to the presents of leaded components, only a single wave
soldering process is encouraged.
Hand Soldering
Hand soldering is possible. Use a soldering iron temperature setting equivalent to 350ºC, follow IPC recommendations/
reference document IPC-7711.
Rework
Matrix Modules can be unsoldered from the host board. Use of a hot air re-work tool and hot plate for pre-heating from
underneath is recommended. Avoid overheating.
!Warning - Never attempt a rework on the module itself, e.g. replacing individual components. Such actions will terminate
warranty coverage.
Additional Grounding
Attempts to improve module or system grounding by soldering braids, wires, or cables onto the module RF shield cover
is done at the customers own risk. The numerous ground pins at the module perimeter should be sufficient for optimum
immunity to external RF interference.
Conformal Coating
Conformal coating may be necessary in certain applications. Please note that the RF shield and the sticker prevent
optimum inflow of liquids or aerosols.
Proper alignment and centering of the module over the pads.
Proper solder joints on all pads.
Excessive solder or contacts to neighboring pads, or vias.
ZMXM-400 Series