CL4490-1000-232-SP Laird Technologies, CL4490-1000-232-SP Datasheet - Page 12
![TXRX 900MHZ RS232 1W W/ANT'S DB9](/photos/14/15/141578/cl4490-1000-232-sp_sml.jpg)
CL4490-1000-232-SP
Manufacturer Part Number
CL4490-1000-232-SP
Description
TXRX 900MHZ RS232 1W W/ANT'S DB9
Manufacturer
Laird Technologies
Series
Connexlink™r
Specifications of CL4490-1000-232-SP
Function
Transceiver
Modulation Or Protocol
FHSS, FSK
Frequency
902MHz ~ 928MHz
Applications
General Purpose
Interface
RS-232
Sensitivity
-99dBm
Power - Output
1000mW
Data Rate - Maximum
76.8 kbps
Features
2 ConnexLink RS232 Units
Voltage - Supply
7 V ~ 18 V
Package / Case
Module
Wireless Frequency
900 MHz
Interface Type
RS-232, RS-485
Board Size
121 mm x 70 mm x 30 mm
Modulation
FHSS, FSK
Security
1 byte System ID, DES
Operating Voltage
100 V to 120 V
Output Power
1000 mW
Antenna
Dipole
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant, Lead free / RoHS Compliant
CL4490 User’s Manual
Note: The Straight Through Cable provided with the CL4490 has female connectors on both ends
and the Crossover cable has a male connector at one end and a female connector at the other
end. Please use a male-to-male adapter or female-to-female adapter wherever required. Using
a null modem adapter with a Crossover cable is equivalent to using a Straight Through cable.
1.5
The RS-485 interface uses a Differential Data Transmission that can help nullify the effects of
ground shifts and induced noise signals that can appear as common mode voltages on a
network.
The CL4490 implements a RS-485 (2-wire Half Duplex) multi-drop interface. Typically, a RS-485
bus will consist of a master and several slaves. The nodes will have unique addresses and can
send addressed packets to specific nodes. Because the bus is half duplex, no two nodes should
try to talk at the same time. The CL4490 does not have a RS-485 address, therefore, it will
transmit all RS-485 traffic over the RF. Conversely, as soon as a CL4490 receives a packet over
the RF, it will transmit the packet over the RS-485 bus.
Note: When using RS-485 (2-wire Half Duplex), a RS-485 to RS-232 converter is required to
configure the unit. AeroComm recommends a B&B Electronics 4WSD9R converter to translate
RS-485 to RS-232.
10/3/2005
RS-485 (2-wire Half Duplex)
OEM Host
DCE
DCD
TXD
GND
DSR
DTR
RI
RXD
CTS
RTS
Figure 7- DCE to DCE Interface
NC
NC
Crossover Cable
NC
NC
TXD
RXD
DTR
GND
DCD
DSR
CTS
RTS
RI
CL4490 Modem
DCE
12