CL4790-1000-232 Laird Technologies, CL4790-1000-232 Datasheet - Page 13
![TXRX 900MHZ RS232 1W W/ANT DB9](/photos/14/15/141573/cl4790-1000-232_sml.jpg)
CL4790-1000-232
Manufacturer Part Number
CL4790-1000-232
Description
TXRX 900MHZ RS232 1W W/ANT DB9
Manufacturer
Laird Technologies
Series
AeroCommr
Specifications of CL4790-1000-232
Function
Transceiver
Modulation Or Protocol
FHSS, FSK
Frequency
902MHz ~ 928MHz
Applications
General Purpose
Interface
RS-232
Sensitivity
-99dBm
Power - Output
1000mW
Data Rate - Maximum
115.2kbps
Voltage - Supply
7 V ~ 18 V
Package / Case
Module
Wireless Frequency
900 MHz
Interface Type
RS-232, RS-485
Board Size
121 mm x 70 mm x 30 mm
Modulation
FHSS, FSK
Security
1 byte System ID, DES
Operating Voltage
100 V to 120 V
Output Power
1000 mW
Antenna
Dipole
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Features
-
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
CL4790 User’s Manual
2.3
6/24/2005
Flow control refers to the control of data flow between the host and the CL4790. It is the
method used to handle data in the transmit/receive buffer of the CL4790 interface, and
determines how data flow between the host and the CL4790 is throttled. Often, in serial
communication, one device is capable of sending data much faster than the other can
receive. Flow control allows the slower device to tell the faster device to pause and resume
data transmission. (Flow control CTS and RTS are used by the CL4790 and its Host, locally
– NOT over the air. Therefore, one CL4790 cannot tell the other to slow down or speed up
as is mentioned above in the paragraph.)
When the RTS Enable option is selected on the Configuration Utility, the transceivers use
hardware flow control to regulate data flow. While using hardware flow control, the
transceiver that is ready to receive data sends a Clear To Send signal to its host (or the
device it is connected to). On the other hand, when a transceiver has something it wants to
send to its host, it checks the state of Ready To Send and if it is logic low, will send data to its
host. If RTS is logic high, it will not send data to its host. These signals are sent apart from
the data itself on separate wires. Note: CTS is always enabled by default. RS-485 Interface
does not support Hardware flow control.
Hardware Flow Control
13