XK-Z11-EBP Digi International, XK-Z11-EBP Datasheet - Page 29

• Manufacturer Part Number: XK-Z11-EBP
• Description: XBEE DEVELOPMENT KIT
• Manufacturer: Digi International
• Type: Transceiver, XBeer

Specifications of XK-Z11-EBP

• Frequency: 2.4GHz
• Wireless Frequency: 2.4 GHz
• Interface Type: RS-232, Ethernet, USB
• Modulation: DSSS
• Security: 128 bit AES
• Operating Voltage: 3.3 V
• Output Power: 50 mW
• Antenna: Dipole
• Operating Temperature Range: - 40 C to + 85 C
• For Use With/related Products: XBee Modules
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 602-1170

LED/button
Associate/
Power LED
Reset/
Ident button
Indicates power and the XBee Wall Router’s ZigBee network association status.
•
•
Performs a reset and multiple functions for commissioning the XBee Wall Router in a
ZigBee network.
Use a small non-conducive tool with a blunt end to press gently and hold down button.
Consecutive button presses must occur within 800 milliseconds of each other to perform the
desired action.
Single
Two
Four
Hold for
five
seconds
Button
press
Solid green: XBee module is powered and not associated to a ZigBee network.
Blinking green: XBee module is powered and has associated to a ZigBee network.
For technical support, call 1-800-903-8430 (US only)
association
Associated
Unassociated
Associated
Associated/
Unassociated
Associated/
Unassociated
Network
If XBee Wall Router is asleep, wakes unit for 30 seconds.
Sends a Node Identification broadcast transmission. All
devices that receive this transmission will blink their
Associate LED rapidly for 1 second. All API devices that
receive this transmission will send a Node Identification
frame out their UART (universal asynchronous
receiver/transmitter) (API ID 0x95).
If XBee Wall Router is asleep, wakes unit for 30 seconds,
then blinks the AI code, a numeric error code, on the Assc
LED, indicating the cause of join failure.
1 blink: Scan found no PANs.
2 blinks: Scan found no valid PANs based on current SC
(Scan Channel) and ID (PAN ID) settings.
3 blinks: Valid Coordinator or Routers found, but they are
not allowing joining (NJ expired).
7 blinks: Node Joining attempt failed.
10 blinks: Coordinator Start attempt failed.
Temporarily enables joining on the XBee Wall Router and
the entire ZigBee network for 1 minute (if the RF module’s
NJ command setting is less than 255). If joining is
permanently enabled on a module (NJ = 255), joining
remains permanently enabled, and this button press has no
effect.
XBee Wall Router leaves PAN, if associated, and issues a
factory reset to restore default parameters in the XBee
module. Default PAN ID is 0.
Performs a hardware reset.
Description
Action
Use gateway to discover nodes
29