MAX19700EVKIT Maxim Integrated Products, MAX19700EVKIT Datasheet - Page 5

• Manufacturer Part Number: MAX19700EVKIT
• Description: EVAL KIT FOR MAX19700
• Manufacturer: Maxim Integrated Products
• Type: Encoder, Decoderr

Specifications of MAX19700EVKIT

• For Use With/related Products: MAX19700
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

30) Set the analog input signal generators to output the
31) Start the MAX19700 program by opening its icon in
32) Normal device operation can be verified by the
33) Click the POR Reset button on the MAX19700 EV
34) Enable the logic analyzer.
35) Capture data using the logic analyzer.
Tx DAC Setup
36) Ensure that a shunt is placed across pins 1 and 2
37) Connect the clock signal generator to the input of
38) Connect the output of the clock bandpass filter to
39) Connect the output of the clock signal generator to
40) Connect the first spectrum analyzer to the EV kit
41) Connect the second spectrum analyzer to the EV
42) Connect the data generator to J11. See the Digital
43) Turn on the -5V power supply.
44) Turn on all remaining power supplies.
45) Plug the CMOD232 wall cube into an electrical outlet.
46) Enable the signal generator.
47) Set the clock signal generator to output a 7.5MHz
desired frequency. The amplitude of the generator
should produce a signal that is no larger than
4.5dBm as measured at the SMA input of the EV kit.
Insertion losses due to the series-connected filter
(steps 18 and 20) and the interconnecting cables
will decrease the amount of power seen at the EV
kit input. Account for these losses when setting the
signal generator amplitude.
the Start menu.
“Status: Interface Board Operational” text in the
Interface box.
kit software GUI.
of jumper JU3.
the clock bandpass filter.
the EV kit SMA connector labeled J10.
the data generator synchronization input.
SMA connector labeled J8 (Q channel).
kit SMA connector labeled J9 (I channel).
Data Bit Locations section in this document for
header connections.
signal. The amplitude of the generator should be
sufficient to produce a 16dBm signal at the SMA
input of the EV kit. Insertion losses due to the series-
connected filter (step 37) and the interconnecting
cables will decrease the amount of power seen at
the EV kit input. Account for these losses when set-
ting the signal generator amplitude.
MAX19700 Evaluation Kit/Evaluation System
_______________________________________________________________________________________
48) Load the desired test pattern into the data genera-
49) Start the MAX19700 program by opening its icon in
50) Normal device operation can be verified by the
51) Click the POR Reset button on the MAX19700 EV
52) Enable the pattern generator.
53) Enable the spectrum analyzers.
54) Analyze the data on the EV kit outputs (J8 and J9)
tor. Data clocked on the rising edge of the clock is
transmitted to the Q channel. Data clocked on the
falling edge of the clock is transmitted to the I
channel.
the Start menu.
“Status: Interface Board Operational” text in the
Interface box.
kit software GUI.
with the spectrum analyzers.
5