ATAB-STK-F Atmel, ATAB-STK-F Datasheet - Page 5

• Manufacturer Part Number: ATAB-STK-F
• Description: BOARD INTERFACE STK500 FLAMINGO
• Manufacturer: Atmel
• Series: Smart RFr
• Type: Interface Boardr

Specifications of ATAB-STK-F

• Frequency: 315MHz
• For Use With/related Products: ATSTK500
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

6. Flamingo
6.1
6.2
4886B–RKE–01/06
Overview
Application Board Interfaces (X1, X2, J37)
™
Interface
To make the Flamingo
tors and interfaces have been mounted on the board. Through these interfaces each RF module
is connected to the underlying microcontroller unit on the STK500.
Figure 6-1.
When using devices of the ATAB5xxx/ATAB862xx series, there are usually two modules
involved: a receiver and a transmitter. The receiver is plugged into sockets X1 and X2 mounted
on the Flamingo. An enlarged picture is shown in the right half of
The transmitter is configured by the STK500 microcontroller. Therefore, it must be plugged into
the socket J37, mounted in the area enlarged in the left part of
tion against short circuits, socket J37 is fitted with a polarizing key between pin 3 and pin 4.
The RF Design Kit software is used to configure the transmitter and receiver.
The LEDs mounted next to J37 are used to indicate different states.
function of each LED.
Table 6-1.
Note:
Label
D1
D2
D3
D4
D5
Note: Jumper J8 (mounted next to port X2) has to be connected when the AVR microcontroller
plugged into the STK500 is capable of recognizing interrupts on its pin PE0 (PE0 = ICP) (for
example, the ATmega8515). It has to be disconnected when using, for example, the ATmega8535.
Connectors and Interfaces
Function of the LEDs
Orange Testword incorrect (microcontroller limits ok)
Yellow
Green
Color
Blue
Red
™
Constant
Flashing
Timing of received testword out of selected microcontroller limit borders
Testword ok and microcontroller limits ok
Communication over RS-232 active
compatible with a wide range of Atmel’s RF products, different connec-
data is being received
Hardware Description Flamingo
AVR
is ready to receive data from the connected receiver
Function
Figure 6-2 on page
Figure 6-2 on page
Table 6-1
describes the
6. For protec-
6.
5