ATR4252-EK Atmel, ATR4252-EK Datasheet - Page 6

• Manufacturer Part Number: ATR4252-EK
• Description: KIT EVAL ANTENNA AMP ATR4252
• Manufacturer: Atmel
• Type: Antennar

Specifications of ATR4252-EK

• Frequency: 150kHz ~ 30MHz, 70MHz ~ 110MHz
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

3.4
3.5
3.6
4. Absolute Maximum Ratings
Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating
only and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of this
specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability.
Reference point is ground.
6
Parameters
Supply voltage
Collector of FM amplifier
AM LNA input terminal
AM LNA output terminal
Power dissipation
Junction temperature
Ambient temperature
Storage temperature
ESD HBM
Supply Voltage Regulator
Antenna Sensor
FM AGC
ATR4252
The IC is equipped with an AGC capability to prevent overdriving of the amplifier in case the
amplifier is operated at strong antenna signals, e.g., near transmitters. It is possible to realize an
additional antenna amplifier path with integrated AGC and external RF transistor. The bandwidth
of the integrated AGC circuit is 900 MHz.
FM amplifier output FMC is connected to a capacitive voltage divider and the divided signal is
applied to the AGC level detector at pin FMDET. This level detector input is optimized for low
distortion. The rectified signal is compared against an internal reference. The threshold of the
AGC can be adjusted by tuning the divider ratio of the external voltage divider. If the threshold is
reached, pin FMPD opens an internal transistor, which controls the pin-diode current. By these
means, the amplifier input signal is limited and therefore the FM amplifier is prevented from sig-
nal overdrive.
The necessary driver for the external pin diode is already incorporated in the ATR4252 IC, which
reduces the BOM cost and the application size.
The driving voltage for an external power transistor is provided by an integrated regulator circuit.
An overvoltage protection circuit recognizes overvoltage condition and switches off the amplifier
and AGC circuits in order to reduce current consumption and avoid thermal overload.
In addition, an antenna sensor has been integrated in order to recognize if the antenna is prop-
erly connected to the amplifier module. If no antenna is detected, the amplifier and AGC circuits
are switched off in order to signal this error via reduction of supply current consumption to the
unit that provides and monitors the supply current for the antenna amplifier (e.g., the car radio).
Pin
11
14
23
26
all
AM LNA OUT
AM LNA IN
Symbol
FMC
V
T
P
T
V
amb
HBM
T
stg
tot
S
j
Min.
–0.3
–40
–50
–2
3
0
7
Max.
1200
+105
+150
+12
150
16
12
+2
2
9154AS–AUDR–09/09
Unit
mW
kV
°C
°C
°C
V
V
V
V