DVK-WLM400 Laird Technologies, DVK-WLM400 Datasheet - Page 21

• Manufacturer Part Number: DVK-WLM400
• Description: DEVELOPMENT KIT WISM+
• Manufacturer: Laird Technologies
• Type: Transceiverr

Specifications of DVK-WLM400

• Frequency: 2.4GHz
• Processor Series: WISM+
• Silicon Manufacturer: Laird Technologies
• Kit Application Type: Communication & Networking
• Application Sub Type: Wi-Fi Intelligent Serial
• Kit Contents: PCB, 2x Antennas, Power Adapter, USB Cable, RS-232
• Rohs Compliant: Yes
• For Use With/related Products: WLM400
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

4.2 Starting WIF.exe
Since WIF.exe uses the USB as the default port, an active USB connection is checked for at launch time, otherwise a
port selection screen will pop up. See the following sections for specific instructions for using USB, serial, Ethernet &
SPI.
4.2.1 Starting WIF.exe over the PC USB port
With the USB driver successfully installed, (see section: “
cable connected between the WISM+ Dev Kit and the PC, WISM+ Dev Kit powered up, and the USB interface
recognized by the PC, launch WIF by clicking…
If everything is working properly, you will see the WIF front screen populated with the current state saved in WISM+
constant memory. Now go to section: “
4.2.2 Starting WIF.exe over the PC Serial port
After setting up the COM port parameters click “OK”.
If everything is working properly, you will see the WIF front screen
populated with the current state saved in WISM+ constant memory.
Now go to section: “
•
•
•
•
© Laird Technology 2010
StartAll ProgramsWism+Wism+ Config Tool
Since WIF.exe is looking for the USB connection upon launch, MAKE SURE THE USB CABLE IS
DISCONNECTED
Make sure that you have exited AT command mode for the WISM+ host COM port as described in section:
“
Now, launch WIF.exe by clicking…
The following interface selection screen will appear…
Configuring PC Serial port for WIF.exe
WIF.exe Operation
.
WIF.exe Operation
StartAll ProgramsWism+Wism+ Config Tool
”.
Click on “Com Port”
and then pull down the
COM port selection box
to select you PCs COM
port. The default
settings for WISM+ is
38400 with No Flow
Control
Configuring PC USB port for WIF.exe
” (issue the “at+quit” command).
”.
Version 1.00
WISM+ DVK MANUAL
”) the USB
Page 16