SDK-AC4486-5A Laird Technologies, SDK-AC4486-5A Datasheet - Page 31

• Manufacturer Part Number: SDK-AC4486-5A
• Description: KIT DESIGN FOR AC4486-5A
• Manufacturer: Laird Technologies
• Series: AeroCommr
• Type: Transceiverr

Specifications of SDK-AC4486-5A

• Frequency: 868MHz
• Mcu Supported Families: AC4486
• Kit Features: Testing And Tuning Antennas, Hardware And Software Integration
• Output Power: 5 mW
• Antenna: MMCX Receptacle
• Silicon Manufacturer: Laird Technologies
• Kit Application Type: Communication & Networking
• Application Sub Type: RF Module
• Kit Contents: 2x RF Module, 2x Adapter Board, CD, 2x AC Power Adapters, 2x DB9
• Rohs Compliant: Yes
• For Use With/related Products: AC4486-5A
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Developer Kit User’s Manual
If these troubleshooting tips do not resolve the problem, please contact the support engineer referenced
on the cover sheet in the SDK binder. Please use our toll free support number at [phone].
Technical support hours are Monday through Friday, 8:00 AM to 5:00 PM Central Standard Time.
10/2/05
Packets can be sent between both radios
using Aerocomm OEM.exe but cannot be
sent from software or hardware not
supplied by Aerocomm.
A Framing or Data Timeout error occurs
while running a Range Test.
5. Make sure one radio is a Server and one is a Client
6. Check radio addressing.
7. Make sure that radios are separated by at least ten
8. Make sure the In Range LED is lit on both
1. Use the Hardware section of this manual to
2. Make sure the baud rate of the radios matches that
3. Make sure the Status 1 LED is not turned on. If so,
1. Verify that the baud rate on the PC Settings page
2. Verify that both radios are powered on and that the
3. Verify that the In Range LED is lit on both radios.
(excluding AC4790).
feet.
transceivers.
determine if a null-modem adapter is required for
interfacing to the hardware.
of the OEM Host hardware.
find out what is driving RTS Low (thus, turning on
the Status 1 LED) and either slide the Program
Mode/Normal Mode switch to Normal, or cause
RTS to go High.
matches that of the radio’s EEPROM.
Port settings are correct.
31