ATAB5428-8-WB Atmel, ATAB5428-8-WB Datasheet - Page 13

• Manufacturer Part Number: ATAB5428-8-WB
• Description: KIT DEMO 868MHZ BLACKBIRD
• Manufacturer: Atmel
• Series: Smart RFr
• Type: Transceiver, UHFr

Specifications of ATAB5428-8-WB

• Frequency: 868MHz
• Maximum Frequency: 868 MHz
• Output Power: 0 dBm to 10 dBm
• Supply Voltage (max): 6 V
• Supply Voltage (min): 3 V
• Supply Current: 21 mA
• Maximum Operating Temperature: + 85 C
• Board Size: 2 in x 3.5 in
• Minimum Operating Temperature: - 40 C
• Product: RF Modules
• For Use With/related Products: ATA5428
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: ATAB-5428-8-WB

5219A–WIRE–04/07
Operating the Transceivers
2.3.3
2-8
TEMPERATURE
SENSOR
HOW TO EXECUTE THE “LINK QUALITY” FEATURE: One transceiver should be left
as a REMOTE at the *WAIT*, antenna icon (blinking) display. When the other trans-
ceiver is put into MASTER mode, it starts sending packets and establishes
communication with the REMOTE. MLINKxx, xxxx, and an antenna icon (blinking)
show on the display. MLINKxx displays the relative signal strength of the signal
received from the REMOTE link's transmitter (00 to 99). xxxx increments to show what
packet number has been successfully sent and acknowledged. The REMOTE displays
the same, except RLINK instead of MLINK.
Exchanges and displays measured temperatures
Note:
P - accesses menu items
L - goes to power-up display (ATMEL SMARTRF...)
U,D - scrolls through menu (DIAGNOSTICS, LINK QUALITY, ...)
FSK - sets transmitter to ASK or FSK
x KBPS - sets data rate
*WAIT*, antenna icon (blinking) - transceiver is in REMOTE mode
MLINKxx, XXXX - transmits to a REMOTE receiver
Mxx, Rxx, counter, AVR and antenna icon (blinking) - Mxx displays signal
strength received from REMOTE's transmitter; Rxx displays signal strength
received from the MASTER's transmitter, as reported from the REMOTE.
CH x - sets radio channel (0 - 9)
Note: One transceiver should be left as a REMOTE at the *WAIT*, antenna icon (blinking)
U - increments channel
D - decrements channel
P - sets mode and goes to x KBPS
L - goes to x KBPS
U,D - toggles between ASK and FSK
P - sets data rate and goes to *WAIT*
L - goes to *WAIT*
U,D - changes data rate (1,5,10 kbps for ASK; 1,5,10,20 kbps for FSK)
L - goes to LINK QUALITY
R - puts transceiver into MASTER mode
L - goes to LINK QUALITY
R + momentary hold - changes display information (Mxx, Rxx, etc.)
L - goes to LINK QUALITY
R + momentary hold - changes display information (MLINKxx, XXXX, etc.)
U - resets counter to 0000
P - sets channel and goes to FSK
L - goes to FSK
U - increments channel
D - decrements channel
display. Proceed with the other transceiver through the remaining menus to establish it
as the MASTER.
this demonstration requires 2 transceivers
ATAB542x-x-WB User Guide