UPC3237TK-A CEL, UPC3237TK-A Datasheet - Page 12

• Manufacturer Part Number: UPC3237TK-A
• Description: IC AMP LOW NOISE 6-MINIMOLD
• Manufacturer: CEL
• Type: Low Noise Wideband Amplifierr

Specifications of UPC3237TK-A

• Current - Supply: 3.5mA ~ 7mA
• Gain: 13dB ~ 17.5dB
• Noise Figure: 1.4dB ~ 1.9dB
• Package / Case: 6-MINIMOLD
• Voltage - Supply: 2.4V ~ 3.3V
• Operating Frequency: 470 MHz to 770 MHz
• P1db: - 5.5 dBm
• Operating Supply Voltage: 2.4 V to 3.3 V
• Supply Current: 5 mA
• Maximum Power Dissipation: 203 mW
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Frequency: -
• Rf Type: -
• Test Frequency: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

NOTES ON CORRECT USE
(1) Observe precautions for handling because of electro-static sensitive devices.
(2) Form a ground pattern as widely as possible to minimize ground impedance (to prevent undesired oscillation).
(3) The bypass capacitor should be attached to the V
(4) The DC cut capacitor should be attached to Input and Output pin.
(5) Pin 1 (NC) should be connected to the ground pattern.
RECOMMENDED SOLDERING CONDITIONS
methods and conditions other than those recommended below, contact your nearby sales office.
12
Infrared Reflow
Wave Soldering
Partial Heating
Caution Do not use different soldering methods together (except for partial heating).
This product should be soldered and mounted under the following recommended conditions.
All the ground terminals must be connected together with wide ground pattern to decrease impedance difference.
Soldering Method
Peak temperature (package surface temperature)
Time at peak temperature
Time at temperature of 220°C or higher
Preheating time at 120 to 180°C
Maximum number of reflow processes
Maximum chlorine content of rosin flux (% mass)
Peak temperature (molten solder temperature)
Time at peak temperature
Preheating temperature (package surface temperature) : 120°C or below
Maximum number of flow processes
Maximum chlorine content of rosin flux (% mass)
Peak temperature (terminal temperature)
Soldering time (per side of device)
Maximum chlorine content of rosin flux (% mass)
Data Sheet PU10675EJ01V0DS
Soldering Conditions
CC
line.
: 260°C or below
: 10 seconds or less
: 60 seconds or less
: 120±30 seconds
: 3 times
: 0.2%(Wt.) or below
: 260°C or below
: 10 seconds or less
: 1 time
: 0.2%(Wt.) or below
: 350°C or below
: 3 seconds or less
: 0.2%(Wt.) or below
Condition Symbol
μ
WS260
HS350
For soldering
IR260
PC3237TK