DEMO90121DA Melexis Inc, DEMO90121DA Datasheet - Page 7

• Manufacturer Part Number: DEMO90121DA
• Description: KIT DEMO RFID DOOR ACCESS
• Manufacturer: Melexis Inc
• Type: RFID (Radio Frequency Identification)r

Specifications of DEMO90121DA

• Contents: Reader Board, Antenna Board, 3 tag cards, Battery, Battery cable, Software and Documentation
• For Use With/related Products: MLX90121
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

MLX90121
13.56MHz RFID Transceiver
8.
Applications Information
This schematic has been optimized to drive a fifty ohms resistive antenna, using a five volts power supply.
Functional description
The transmitter output TX is connected to the supply by means of a choke L3. C3 is added to avoid a high
dV/dt at the TX output in case of a sudden interruption of the current in the choke. C3 is chosen high
enough to protect the chip, but low enough to keep the resonance of L3-C3 well above 13.56 MHz.
The transmitter signal is coupled with DC blocking capacitor C2 to the antenna matching network, which is
a T network made up by L2, CV1 and L1. CV1 allows a proper matching between the 50Ohm antenna
and the output impedance of the transmitter stage.
The receiver part of the chip gets its signal directly from the antenna by means of R1. It limits the voltage
swing at the RX pin to a level in between the supplies.
One should take care to properly decouple the power supplies of the chip. Especially the Vdd1 supply
which is used for the transmitter output. Any amplitude noise on that supply is AM modulated on the
carrier and will hence be perceived as noise by the receiver part. The same holds for any phase noise that
gets introduced into the quartz oscillator.
For the signal that goes to- and from the microcontroller: one should take care to keep them as far as
possible from the analog parts and the quartz oscillator. To do a first evaluation, it is highly recommended
to use the MLX90121 evaluation board that can be ordered from Melexis. The clock for the microcontroller
can also be derived from the XBUF pin. This pin provides a 13.56MHz buffered clock or 13.56MHz divided
by 2.
3901090121
Page 7 of 26
Data Sheet
Rev. 009
Sept.-2009